RAMPAGE PRODUCTS Front Double Tube Bumper Installation guide

Hello! I've reviewed the installation instructions for the Rampage Products Front Bumper Guard models 86420, 86620, and 88625. The document details the steps for installation on a Jeep Wrangler 4-door 2007-12 model, including how to remove the old bumper, install new brackets, and attach the new bumper guard. It also highlights the bolt sizes needed and offers visual guides. I'm ready to help answer any questions you might have about the installation process or the product itself.
What tool is needed to remove the factory bumper?

How many mounting bolts are used per side to remove the factory bumper?

What size bolts are used for the new bumper?

Installation Instructions

PART#:86420, 86620 and 88625

Front Bumper Guard for Jeep Wrangler 4-door 2007-12

PARTS LIST

1 Front Bumper

2 Brackets

8 12MM X 35MM bolts

8 12MM nylon lock nuts

16 12MM washers

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY.

2. Unplug the bumper lights electrical connections (Fig 1)

3. Remove front factory bumper by removing the eight mounting bolts with a 17MM

socket wrench (Fig 1)

4. Install the new bumper brackets as shown in photos. Note that the bracket faces

rearward and the forward facing holes (those the mounts bolt onto the frame) are

horizontal, and those the bumper mounts to are vertical. (Fig 2)

5. Install the 12MM bolts and locking nuts to the mounts but leave finger tight to allow for

adjustment

6. Install the 12MM bolts and locking nuts to the bumper and the mount.

7. Adjust the bumper and tighten all the bolts. (Fig 3)

Bumper light plug

Four mounting bolts

per side

Fig 3

Fig 1

Fig 2 Note the orientation of the bolt holes

Rampage Products www.rampageproducts.com

Corona, CA (951) 277-4949