2. Ghent
  3. PEC2442-T

Ghent PEC2442-T Operating instructions

  • Hello! I've reviewed the installation instructions for the ghent Partition Extender model PEXXXXX-T. This document details the steps for assembling the product, including mounting the acrylic panel with standoffs, cleaning the surface, and securing the unit using adhesive tape. I'm ready to assist with any questions you have about the installation or the product itself.
  • How many sets of brackets are included for custom sizes?
    How many sets of brackets are included for standard sizes with panel width larger than 48"?
    How many sets of brackets are included for all smaller sizes?
    What size screw is used to assemble standoffs and feet?
    What should be used to clean the mounting surface?
Acrylic
Panel
Standoff with
Nylon Tipped
Set Screw
Foot
Screw
5/16-18 x 1/2"
flat head
3mm Allen
Wrench
3/16" Allen
Wrench
Partition Extender / PEXXXXX-T
Adhesive Unit
IInstallation Instructions
www.ghent.com/install - Lebanon, Ohio 800-543-0550
IS-PE-T 7/20
Step 1:
Remove and unpack the Arylic Panel, Brackets, and Hardware.
Step 2:
Assemble all Standoffs and Feet
together using the 5/16-18 x 12" flat head screw.
Step 6:
Recycle all packaging in accordance to local regulations.
Step 3:
Slide the Acrylic Panel into the
Standoffs. Secure the Acrylic Panel by
tightening the set screws in the Standoff with
the provided Allen Wrench.
Step 5:
Remove the liner on the tape (located on the bottom of the Foot) and secure
to the top of the desk/table using firm pressure.
Step 4:
Clean the mounting surface with isopropyl alcohol or similar to remove all
dust, dirt, or debris
Note: Custom sizes with panel width larger than 72" will receive 4 sets of brackets. Standard sizes
with panel width larger than 48" will receive 3 sets of brackets, all smaller sizes will receive 2 sets.
/