Krosswood Doors PC-WS-W2142 Operating instructions

Type
Operating instructions

This manual is also suitable for

Assembly Instructions
1 Door Upper Cabinet
Wood
Dowel
Cam-Lock
Screw
Cam-Lock
Nut
¾” Screw
Bumpers
2 Piece
Hinge X 2
Back Panel
Top and
Bottom Panel
Side Panel
X 2
Shelf
1
2
3
4
Insert
dowels
after glue
drops
Slide in Back Panel
Tighten Cam-Lock Nut
Set 2
nd
Side Panel
Tighten Cam-Lock Nut
Tools needed but not provided:
Phillips Screwdriver
Wood Glue
½” Screw
Door
* Number of shelves will vary
with cabinet height
T (Top)
B (Bottom)
*Top and Bottom are Identical
*Do not put glue directly on the dowel
*Place 2-3 drops of glue in the hole
before inserting each dowel
T
B
Back
Panel
T
B
Back
Panel
I
I
I
I
Shelf Clips
X8
*Do not Fully tighten ½”
hinge screws until step 8
Side 1
Side 2
(Right Hinge)
*Side Panels are Identical
*Place 2-3 drops of glue in side
panel holes before attaching Top
and Bottom Panels
X 2
*Push all the way in until less
than 3/8” of dowel is exposed
C A B I N E T S
B y M o d e r n C l a s s i c
*Right Hand Hinge Placement
Shown Throughout
*Screw in Cam-Lock Screw until
threads are no longer visible
X 8
*If you would like a Left
Hinge door: apply hinge
base to Left Panel.
Drawing shows Right
Hinge
X 4
X 4
Set shelves to desired heights
er Shelf
X 4
¾” screw in
each of the
holes
5
8 9
7
Apply
Bumpers
½” Screws
X 4
Hinge Adjustment as Needed For Door Alignment
(In/Out)
12” to 18” = 0 Shelves
19” to 24” = 1 Shelf
25” to 36” = 2 Shelves
37”to Larger = 3 Shelves
Incorrect
Correct
Side-Side
Up-Down
Front-Back
2. Once hinge is hooked,
press until it snaps in place
1. Hook hinge in front plate
3. Tighten ½” screws
from Step 2
6
  • Page 1 1
  • Page 2 2

Krosswood Doors PC-WS-W2142 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI