Euri Lighting ET8-2150T-12 Installation guide

Brand: Euri Lighting

Model: ET8-2150T-12

Type: Installation guide

USE LED LAMPS ONLY. THIS LUMINAIRE HAS

BEEN MODIFIED TO USE LED LAMPS AND

CAN NO LONGER OPERATE THE ORGINALLY

INTENDED FLUORESCENT LAMPS SAFELY.

FLOURESCENT LAMPS COULD BREAK AND CAUSE PERSONAL INJURY

IF USED IN THIS FIXTURE.



WARNING!

INSTALLATION GUIDE

MODEL #:

ET8-2140T-12 / ET8-2150T-12 / ET8-2140T-15 / ET8-2150T-15

For customer service please call us at 1-888-743-5766

Ofce Hours: 8:00 a.m. – 5:00 p.m. PST Monday-Friday

Questions?



WARNING!

DOUBLE ENDED INSTALLATION IS NOT RECOMMENDED

DUE TO POTENTIAL RISK OF FIRE OR ELECTRIC SHOCK

THIS PRODUCT MAY NOT BE COMPATIBLE WITH ALL BALLASTS, FOR MORE INFORMATION ABOUT BALLAST COMPATIBILITY PLEASE VISIT: WWW.EURILIGHTING.COM

Linear Series | T8 Class

4 ft. Bypass Ballast LED Tube

PLEASE REVIEW THE INSTRUCTIONS AND WARNINGS LISTED BELOW PRIOR TO PROPER INSTALLATION

This LED lamp is intended to replace uorescent t8 tube lamps with an ANSI designation 32W/48T8/RS, 32W/48T8

WARNINGS CAUTIONS

• Risk of fire

• LED tube bypass ballast installation requires knowledge of

luminaire electrical systems.

(If you are not a qualified electrician, please do not attempt installation.)

• Risk of electric shock – turn-off power at source before installation

• Do not make or alter any open holes in an enclosure of wiring or

electrical components during installation.

• If lamp or luminaire exhibits abnormal operation (buzzing, flickering,

minimal light, etc.), turn off power, remove lamp and contact us. For

more information please visit www.eurilighting.com or call our toll-free

number 1-888-743-5766.

• Do not use with dimmers.

• Do not look directly at the operating Bypass Ballast LED T8 Lamp.

• Do not touch this product with wet hands.

• Do not disassemble, repair or alter lamp.

• Designed for indoor applications only.

• Suitable for damp locations.

• The luminaires shall be grounded.

• Avoid contact with lamp pins during installation.

• This Device is not intended for use with emergency exits or

emergency lights.

WHEN BYPASSING A BALLAST ALWAYS HAVE A QUALIFIED ELECTRICIAN DO YOUR ELECTRICAL WORK.

BYPASS BALLAST INSTALLATION INSTRUCTIONS

Single Ended Bypassing of Magnetic / Electronic Ballast

1. Turn-off power before installation.

2. Remove the existing ballast and existing starter (If present)

3. Replace uorescent tube with LED Tube

4. Remove any pre-existing labels and replace them with the labels provided with this product.

FOR BYPASS INSTALLATION

SINGLE ENDED INSTALLATION ONLY.

(

PROFESSIONAL INSTALLATION IS REQUIRED.)

STEP 3

L N

LED Tube

MAGNETIC BALLAST

STEP 1 STEP 2

(continue to step 3 below)

L N

Fluorescent Lamp

Magnetic Ballast

Traditional Starter

L N

LED Tube

Magnetic Ballast

Traditional Starter

STEP 1 STEP 2 (continue to step 3 below)

STEP 4

ELECTRONIC BALLAST

L N

LED Tube

Electronic Ballast

Fluorescent Lamp

Electronic Ballast

Bypass Ballast

Remove any pre-existing labels and replace them

with the labels provided with this product.

Use end labeled with letter “A”

Euri Lighting ET8-2150T-12 Installation guide

Euri Lighting ET8-2150T-12 Installation guide

Euri Lighting ET8-2150T-12 Installation guide

Related papers

Other documents