RAB Lighting T8-6-24G-830-DIR Operating instructions

Brand: RAB Lighting

Model: T8-6-24G-830-DIR

Type: Operating instructions

This manual is also suitable for

INSTRUCTIONS

LED T8 Tube Series

RAB Lighting is committed to creating high-quality, aﬀ ordable, well-designed and energy-eﬃ cient LED lighting and controls that make it easy for electricians to install

and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]

T8-6-24G-8XX-DIR

PRODUCT FEATURES

INSTALLATION INSTRUCTIONS (cont’d)

· U L c e r t i ﬁ e d

· Plug-n-Play replacement

· Full glass housing: no aging, yellowing, bending

· Compatible with programmed start electronic ballasts

· Product applications: widely used in residential buildings,

oﬃ ces, shopping malls, supermarkets, hospitals, assembly lines,

warehouses, etc. for energy-saving illumination.

SAFETY PRECAUTIONS

WARNINGS:

• Make certain power is OFF before installing or maintaining ﬁ xture.

• RISK OF FIRE. USE ONLY IN PLACE OE FLUORESCENT LAMPS SPECIFIED ON LABEL.

• RISK OF ELECTRIC SHOCK. DO NOT USE WHERE DIRECTLY EXPOSED TO WATER. SUITABLE FOR DAMP LOCATIONS.

SAFETY INFORMATION:

(1) Check the lamp before installation, if there is any damage caused during transportation, do not install.

(2) Maintenance should be carried out by technical personnel only.

(3) Keep the lamp away from flame or high temperature objects.

(4) Only for indoor use.

(5) If the glass lamp tube is broken, the lamp must be disposed of immediately!

(6) Not for use with light dimmers or emergency ballast.

These devices are suitable for use in dry or damp locations. They employ non-replaceable light sources. They are not intended for use

with emergency exits.

LED T8 lamp for use only with products described and installed in accordance with product specifications. LED T8 lamp to be

operated with fluorescent electronic ballast.

INSTALLATION INSTRUCTIONS

4) Bring LED lamp to luminaire and insert lamp pins

into luminaire lamp holders

6) Place lens or diffuser back in place (if applicable)

7) Power ON.

5) Rotate LED lamp until lamp locks in place. Ensure that the LED

lamp front points away from the back of the luminaire.

Note: install LED T5 replacement lamp one for each fluorescent

lamp removed.

1) Make Sure power is OFF

2) Remove lens or diffuser (if applicable)

3) Remove existing fluorescent lamps from the luminaire

INSTRUCTIONS

LED T8 Tube Series

RAB Lighting is committed to creating high-quality, aﬀordable, well-designed and energy-eﬃcient LED lighting and controls that make it easy for electricians to install

and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: mar[email protected]

WARNING

DO NOT INSTALL THIS LAMP IN A PRE-HEAT LUMINAIRE.

NOT SUITABLE FOR ENCLOSED LUMINAIRES.

THIS LAMP ONLY OPERATES ON ELECTRONIC BALLASTS.

If lamp does not light when the luminaire is energized,

remove lamp from luminaire and contact lamp manufacturer

or qualified electrician.

CAUTION RISK OF FIRE. If the lamp or luminaire exhibits

undesirable operation (buzzing, flickering, etc.), immediately

turn off power, remove lamp from luminaire and contact

manufacturer.