RAB Lighting T8-12-48G-850-DIR-G2 Operating instructions

Brand: RAB Lighting

Model: T8-12-48G-850-DIR-G2

Type: Operating instructions

This manual is also suitable for

INSTRUCTIONS

LED T8 Tube Series - Ballast Compatible

RAB Lighting is committed to creating high-quality, aﬀordable, well-designed and energy-eﬃcient LED lighting and controls that make it easy for electricians to install

and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

RAB LED tubes must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is

required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON

FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING:

1. Risk of shock. Disconnect power before installation.

2. LED T8 lamp for use only with products described and installed in accordance with product speciﬁcations. LED T8 lamp to

be operated with ﬂuorescent electronic ballast.

3. RISK OF FIRE, USE ONLY IN PLACE OF FLUORESCENT LAMPS SPECIFIED ON LABEL. RISK OF ELECTRIC SHOCK-DO NOT USE

WHERE DIRECTLY EXPOSED TO WATER, SUITABLE FOR DAMP LOCATIONS.

INSTALLATION INSTRUCTIONS

1. Turn Power OFF

2. Remove lens or diﬀuser (if applicable)

3. Remove existing ﬂuorescent lamps from the luminaire.

4. Bring LED lamp to luminaire and insert lamp pins into

luminaire lamp holders

5. Rotate LED lamp until lamp locks in place. Ensure that the LED

lamp front points away from the back of the luminaire.

6. Place lens or diﬀuser back in place (if applicable)

7. Switch power ON.

OFF

Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation, operation or maintenance.

5. For the compatible ballast list, please refer to RAB’s website - rablighting.com.

4. DIRECT REPLACEMENT FOR 32W/48T8, 30W/48T8, 28W/48T8, 25W/48T8 LAMPS ONLY

T8-12-48G-8XX-DIR-G2

INSTRUCTIONS

LED T8 Tube Series - Ballast Compatible

RAB Lighting is committed to creating high-quality, aﬀordable, well-designed and energy-eﬃcient LED lighting and controls that make it easy for electricians to install

and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]

SAFETY INFORMATION MAINTENANCE NOTES

1. Check the lamp before installation, if there is any damage

caused during transportation, do not install.

2. Maintenance should be carried out by technical personnel only.

3. Keep the lamp away from ﬂame or high temperature objects.

4. Only for indoor use.

5. If the glass lamp tube is broken, the lamp must be disposed

immediately!

6. Not for use with light dimmers or emergency ballast.

1. Disconnect lamp from power supply before any maintenance.

2. Clean luminaire with dry cloth.