2. Ford
  3. 415-00
415-00

Ford 415-00 User manual

  • Hello! I've reviewed the user manual for the Ford Bronco A-Pillar speaker removal and installation. The document provides step-by-step instructions, including torque specifications and the required tool. I'm ready to answer any specific questions you might have about the procedure.
  • What special tool is needed for this procedure?
    What is the torque specification for the instrument panel grab handle screws?
    What is the torque specification for the driver foot rest nuts?
1/4/22, 7:13 PM
Page 1 of 8https://www.fordtechservice.dealerconnection.com/publication/proc…%20and%20Installation%3A%3AA-Pillar%20Speaker&goToHash=#G2203277
415-00 Information and Entertainment System - General Information 2021 Bronco
Removal and Installation Procedure revision date: 03/30/2021
A-Pillar Speaker
Special Tool(s) / General Equipment
Interior Trim Remover
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
NOTE: Left hand (LH) shown, right hand (RH) similar.
1. Remove the screws and the instrument panel grab handle.
Torque: 80 lb.in (9 Nm)
2. Release the clips and remove the cowl side trim panel.
Use the General Equipment: Interior Trim Remover
1/4/22, 7:13 PM
Page 2 of 8https://www.fordtechservice.dealerconnection.com/publication/proc…%20and%20Installation%3A%3AA-Pillar%20Speaker&goToHash=#G2203277
3. On 3-door vehicles.
Release the clips and remove the front scuff plate trim panel.
Use the General Equipment: Interior Trim Remover
1/4/22, 7:13 PM
Page 3 of 8https://www.fordtechservice.dealerconnection.com/publication/proc…%20and%20Installation%3A%3AA-Pillar%20Speaker&goToHash=#G2203277
4. On 5-door vehicles.
Release the clips and remove the front scuff plate trim panel.
Use the General Equipment: Interior Trim Remover
Left hand lower cowl side panel panel
5. Release the clips and remove the driver foot rest trim panel.
Use the General Equipment: Interior Trim Remover
1/4/22, 7:13 PM
Page 4 of 8https://www.fordtechservice.dealerconnection.com/publication/pro…%20and%20Installation%3A%3AA-Pillar%20Speaker&goToHash=#G2203277
6. Remove the driver foot rest nuts.
Torque: 28 lb.in (3.2 Nm)
1/4/22, 7:13 PM
Page 5 of 8https://www.fordtechservice.dealerconnection.com/publication/proc…%20and%20Installation%3A%3AA-Pillar%20Speaker&goToHash=#G2203277
7. Release the clips and remove the LH A-pillar speaker grille.
Use the General Equipment: Interior Trim Remover
8. Release the clips and remove the LH lower cowl side panel panel.
1/4/22, 7:13 PM
Page 6 of 8https://www.fordtechservice.dealerconnection.com/publication/pro…%20and%20Installation%3A%3AA-Pillar%20Speaker&goToHash=#G2203277
Right hand lower cowl side panel panel
9. Release the clips and remove the RH A-pillar speaker grille.
Use the General Equipment: Interior Trim Remover
1/4/22, 7:13 PM
Page 7 of 8https://www.fordtechservice.dealerconnection.com/publication/proc…%20and%20Installation%3A%3AA-Pillar%20Speaker&goToHash=#G2203277
10. Release the clips and remove the RH lower cowl side panel panel.
All vehicles
1/4/22, 7:13 PM
Page 8 of 8https://www.fordtechservice.dealerconnection.com/publication/pro…%20and%20Installation%3A%3AA-Pillar%20Speaker&goToHash=#G2203277
NOTE: Left hand speaker is shown, right hand speaker is similar.
11. Disconnect the electrical connector, remove the screws and the A-pillar speaker.
Torque: 19 lb.in (2.2 Nm)
Installation
1. To install, reverse the removal procedure.
© Copyright 2022, Ford Motor Company.
/