2. Ford
  3. 415-00C
415-00C

Ford 415-00C User manual

  • I've reviewed the user manual for the SYNC 3 MKX, focusing on the removal and installation of the Front Controls Interface Module (FCIM). The document provides step-by-step guidance, including the necessary tools, torque specifications, and important notes for both removal and installation. I'm ready to assist you with any questions you have regarding this procedure.
  • What tool is needed to remove the trim panels?
    What should I do before removing the module, if I'm installing a new module?
    What is the torque for the media bin assembly bolts?
7/14/22, 7:19 PM
2016 MKX
https://www.fordtechservice.dealerconnection.com
1/6
415-00C Information and Entertainment System - General Information - Vehicles With:
SYNC 3
2016 MKX
Removal and Installation Procedure revision date:
12/19/2017
Front Controls Interface Module (FCIM)
Special Tool(s) / General Equipment
Interior Trim Remover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool
prior to removing the module. This information must be downloaded into the new module after installation.
Using a diagnostic scan tool, begin the PMI process for the FCIM following the on-screen instructions.
2. Open the floor console arm rest.
3.
Release the clips and remove the floor console trim panel.
Disconnect the electrical connector.
Use the General Equipment: Interior Trim Remover
7/14/22, 7:19 PM
2016 MKX
https://www.fordtechservice.dealerconnection.com
2/6
4. Release the clips and remove the RH floor console upper trim panel.
Use the General Equipment: Interior Trim Remover
5. Release the clips and remove the LH floor console upper trim panel.
Use the General Equipment: Interior Trim Remover
7/14/22, 7:19 PM
2016 MKX
https://www.fordtechservice.dealerconnection.com
3/6
6. Open the media bin.
7.
Remove the media hub.
Disconnect the electrical connectors.
Use the General Equipment: Interior Trim Remover
7/14/22, 7:19 PM
2016 MKX
https://www.fordtechservice.dealerconnection.com
4/6
8. NOTE: On both sides.
Position the floor console upper side trim panel aside.
9.
Remove the bolts, release the clips and remove the media bin assembly.
Disconnect the electrical connectors.
Torque: 22 lb.in (2.5 Nm)
7/14/22, 7:19 PM
2016 MKX
https://www.fordtechservice.dealerconnection.com
5/6
10.
Release the clips and remove the instrument panel speaker grille.
Disconnect the electrical connector.
Use the General Equipment: Interior Trim Remover
1. 11. Remove the bolts.
Torque: 22 lb.in (2.5 Nm)
2. Remove the screws.
Torque: 11 lb.in (1.2 Nm)
3. Disconnect the electrical connectors and remove the FCIM .
7/14/22, 7:19 PM
2016 MKX
https://www.fordtechservice.dealerconnection.com
6/6
Installation
1. To install, reverse the removal procedure.
2. NOTE: This step is only necessary if replacing the component.
Using a diagnostic scan tool, complete the PMI process for the FCIM following the on-screen instructions.
© Copyright 2022, Ford Motor Company.
/