Installation Instructions

1. Tape this template to the drywall.

Center the template between the studs. Make sure that

13 1/4”W x 21”H x 3”D is available for the speaker and

installation blocks.

2. Mark the location of holes.

Use a punch or screw to mark holes #1 through 18 at the top

and bottom of the template.

3. Remove the template and drill holes.

5. Install the installation blocks and springs.

Using 14 of the supplied drywall screws, attach the

installation blocks to the top and bottom of the speaker cutout.

(Figures 1 and 4)

6. Connect the speaker wires.

Using the supplied wire nuts, connect the speaker observing

proper polarity. Place the speaker on the springs, and loosely

secure it using the supplied screws. A slow screw gun is ideal

for this operation.

7. Flush the speaker to the wall.

conditions.

9. Tape and mud over the speaker.

The total thickness of the drywall compound and texture

(if any) must not exceed 1/16”.

10. Wait at least 2 days.

Let the drywall compound dry completely.

11. Check for ghosting.

Apply a thin skim coat of mud if the speaker begins ghosting.

12. Paint over the speaker and wall.

Paint, and allow the area to dry completely before using

Placement

Leveling

Mudding

• A thin coat of drywall compound and texture, less than 1/16”, is

all that’s required to hide the speaker.

Note

Invisibility of the Kameleon speaker is predicated on the skill of the

drywaller. Standard level 5 finishing is required to ensure a high

quality finish.

Speaker Cutout

Stud

8

10

11

12

13

14

15

16

Install springs in

the outer cavities

for 1” drywall.

Figure 1 Figure 2

Tape the edges and finish the area using drywall com-

• Safe to use in humid and outdoor areas like showers and marine

environments.

To avoid unwanted bumps in the finished drywall, set the speaker as

flush to the wall surface as possible.

• For a smoother finish, sand around the entire perimeter of the

speaker location after the mud has completely dried. Sanding

eliminates shrinking marks and ensures a flat, even finish.

• If scratches or bubbles are visible after sanding, apply one

additional “skim coat” after the first coat of mud. Sand lightly

after it dries completely.

60 Hz, 22 kHz

Sensitivity (SPL, 1W, 1m) 87 db

This SnapAV® product has a 5 year Limited Warranty. This warranty includes parts and labor repairs on all components found to be

defective in material or workmanship under normal conditions of use. This warranty shall not apply to products which have been

abused, modified or disassembled. Products to be repaired under this warranty must be returned to SnapAV or a designated service

center with prior notification and an assigned return authorization number (RA).

Stud

131126-1430© 2013 Episode ®

Por favor vea el reverso para instrucciones en Español