!
!
!
!
!
!
!
!
!! !
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
"#$%&'()!*+',-),%!($!./012!3-'4!56!0+'7(,#!8,)+9-)!:#,!;#$(,'(,%!56!<=!":(,-(!*:>!:-%!3-(,#-:(+$-:?!@$;6!
A+97(!*:>4!"#$(,'(,%!":(,-()!+-'?&%,!<=!":(,-(!BCDEEFEGH!BCEFIEJKH!BFIKCLJL4!M(7,#!;:(,-()!:-%!
'$-(+-&: -',)!;,- %+ -94!. /012!;#$%&'(!'$-N+9&#:(+$-)!:?)$!;#$(,'(,%!56!3-(,#-:(+$-:?!O#:%,!8#,))!*:>4!1??!
8,)+9-) !:-%!" :( ,-( !+-N#+ -9,P ,-()!>+? ?!5,!;#$),' &(, %!( $!(7,!N&?? !,Q(,-(!$N!(7,!?:>4!!
!
!
0$#!O,'7-+':?!=&;;$#(H!"?,:),!@:??!LEK/EEJ/CGLL!
./012!3-'4H!KLGJL!=7+?$7!@7&#'7!A%4H!R$&)($-H!OS!FFJCC!
Installation)Instructions)
EJ/TC!0$#%!0KDJU0LDJU0GDJ!
!
Installation Instructions for
80-96 Ford F250 / F350
80-96 F150
Bolt Kit:
24)3/8x1½”carriagebolts
24)3/8”nuts
24)3/8”washers
Tools Needed:
15mmor9/16”wrench/socket
Drilland½”drillbit.
Find the driver and passenger sides; the short end (tail) goes towards the
front.
1. Look on the underside of the truck cab, right below the door. You
willseeatroughbetweenthestiffingriblocated@5”fromthe
vertical sheet metal that makes up the outside panel of the truck.
This is where the brackets will fit butted up against the stiffing rib
and the horizontal floor pan.
2. Hold the Nerf-steps in place. The leading edge of the bars should
beabout¾”fromthefrontwheelwellopening.
3. Mark all the holes using the marker where they line up on the sheet
metal in the trough.
4. Drillalltheholesusingthe½”drillbit.Holdbarsupsoholeline
up
5. Put the carriage bolts in the holes faced down in the door seal.
Then the bolts in the backbone of the bracket to the stiffing rib.
6. Once all bolts are finger tight, take a wrench and tighten all the
lowerboltfirst,thentightentheupperones…therewillbeagap
between the bracket, once you tighten them it will load it to the
cab.
7. Repeat the process on the other side. You are now DONE!
Questions: Call (281) 880-NFAB