N-Fab Rock-Rails Installation guide

Hello! I've reviewed the installation instructions for the N-FAB Rock Rail J072RKR/J074RKR designed for the 07-15 Jeep JK Wrangler. The document outlines a step-by-step process, using existing body mount nuts, and includes torque specifications. I'm ready to answer your questions about these rock rails and the installation process.
What tools are needed for installation?

Which side should I start with?

What is the torque specification?

"#$%&'()!*+',-),%!($!./012!3-'4!56!0+'7(,#!8,)+9-)!:#,!;#$(,'(,%!56!<=!":(,-(!*:>!:-%!3-(,#-:(+$-:?!@$;6!

A+97(!*:>4!"#$(,'(,%!":(,-()!+-'?&%,!<=!":(,-(!BCDEEFEGH!BCEFIEJKH!BFIKCLJL4!M(7,#!;:(,-()!:-%!

'$-(+-&:-',)!;,-%+-94!./012!;#$%&'(!'$-N+9&#:(+$-)!:?)$!;#$(,'(,%!56!3-(,#-:(+$-:?!O#:%,!8#,))!*:>4!1??!

8,)+9-)!:-%!":(,-(!+-N#+-9,P,-()!>+??!5,!;#$),'&(,%!($!(7,!N&??!,Q(,-(!$N!(7,!?:>4!!

0$#!O,'7-+':?!=&;;$#(H!"?,:),!@:??!LEK/EEJ/CGLL!

./012!3-'4H!KLGJL!=7+?$7!@7&#'7!A%4H!R$&)($-H!OS!FFJCC!

Installation)Instructions)

A$'T/A:+?)!

JF/KD!U,,;!UV!W#:-9?,#!

":#(!.&P5,#)X!

UJFLAVAYUJFIAVA!

Installation Instructions for 07-15 Jeep JK Rock-Rail Models

J072RKR & J074RKR

Please read instructions entirely before installing product. It is recommended to

have assistance while performing the install.

This part uses the nuts located in the body mounts and does not require additional

hardware.

Tools Needed:

Torque Wrench Ratchet 18mm Socket

Step 1. Locate the front and rear body buckets where the body mounts to the frame. NOTE: There are

three body buckets per side.

Step 2. Start with the driver side. NOTE: The end with the cap is the rear of the bar.

Step 3. Remove the smaller nuts next to each large body mount washer on the front and rear body mount.

Step 4. LocatetheRockRail’sfrontmountandrearmount.

Step 5. Slide the Rock Rail over the large body mount washers in the front and rear body buckets.

Step 6. Take the nuts removed from the body buckets and loosely bolt the Rock Rail on.

Step 7. Once all four nuts are in place, tighten to 30 lbs.

Step 8. Repeat this process on the opposite side.

Step 9. If you have the detachable steps (part # JPTS32) you can bolt one per side at this time.

This concludes the installation.

Questions? Call 281-880-6322

Products licensed to N-fab Inc. by Fichter Designs are protected by US patent law and International Copy Right law. US Patent #

6855783, # 6874801, # 7416202. Other patents and continuances pending. N-fab products configuration also protected by

International Trade Dress Law. All Design and Patent infringements will be prosecuted to the full extent of the law.