2. N-Fab
  3. J9746

N-Fab J9746, J9756U, Nerf-Steps Installation guide

  • Hello! I've reviewed the installation instructions for the n-FAB Nerf Steps J9746 and J9756U designed for the 97-06 TJ Jeep. The document provides a detailed, step-by-step guide and diagrams to help you install these steps using factory hardware. I'm ready to answer any questions you may have about the installation process or the product itself.
  • What is the first step of the installation?
    What hardware is used for installation?
    What should one do after installation ?
12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281) 880-6325
PART NUMBER: J9746, J9756U
PRODUCT: NERF STEPS
APPLICATION: 97-06 TJ JEEP
INSTRUCTIONS:
Step 1: Starting with the driver side, remove the three body mount bolts with bushings. and set
aside. Fig. A
Step 2: Next, install the factory body bolts and bushings into the Nerf-steps center and rear
bracket with the bushing on top of the mount creating an assembly. Fig. B
PARTS INCLUDED: QTY
Driver Side Step 1
Passenger Side Step 1
Uses Factory Hardware
Body Mount Bolt
And Bushing
Fig. A
Fig. B
Step 3: Carefully raise step up into position aligning the brackets with the factory mounts and
thread the bolts loosely. Fig. C
Step 4: Next, install the front body bolt and bushing and loosely tighten... NOTE: Be sure the
round opening in the step bracket fits around the upper body bushing and set s flush with
body mount not to pinch the bushing. Fig. D
Step 5: Tighten all hardware to factory specs starting with the center bracket then front and
rear.
Step 6: Repeat steps 1-4 with passenger side. NOTE: Check all factory hardware periodically
for tightness to ensure safety and longevity of steps.
Front Bracket
Round opening
Rubber Bushing
Fig. D
Fig. C
Bushing on
Bottom of Bracket
Body Bushing
On Top of Bracket
12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281) 880-6325
PART NUMBER: J9746, J9756U
PRODUCT: NERF STEPS
APPLICATION: 97-06 TJ JEEP
/