2. Fishbone Offroad
  3. FB31117

Fishbone Offroad FB31117 Installation guide

  • Hello! I've reviewed the installation instructions for the Fishbone Offroad JK Wrangler Logo Inner Fender Accent Plates. This document outlines the steps for preparing, painting, and installing the accent plates to your vehicle's inner fenders. It also includes the necessary tools and materials you'll need. I'm ready to assist with any questions you have about the installation process or the product itself.
  • What tools are required if the inner fender is uninstalled?
    What is the first step to prepare the plates?
    What kind of tape is included?
FB31117
Jeep® JK Wrangler
Logo Inner Fender Accent Plates
REQUIRED TOOLS
*If inner fender is
uninstalled:
-1/4” Drill Bit
-10MM Wrench
-3MM Allen Key
-Paint
*If inner fender is installed:
-Paint
KIT CONTAINS
RAW Aluminum Accent Plate
Sheet of 3M Foam Adhesive Tape
NOTE: THIS PRODUCT IS EXCLUSIVE
TO FISHBONE OFFROAD’S LOGO
ALUMINUM INNER FENDERS,
PART# FB33073
QTY
2
1
*Inner Fender NOT Included
FB31117
Jeep® JK Wrangler
Logo Inner Fender Accent Plates
1
1) PREPARE ACCENT PLATES
Begin coloring your Accent by first priming them,
followed by painting them the color of your choice.
Ensure that the plates are lying down as shown
below so that only the visible face is painted.
2) APPLY ADHESIVE
Place the adhesive strips around the boarder of the
painted face. The tape provided is not cut to size
and may need trimmed depending on how you
decide to lay it out.
3) INSTALL PLATE
Remove the backings of the tape and firmly press
the plate up against the backside of the
corresponding Logo Inner Fender. ………………………….
You may need to bow the aluminum back and forth
to ensure the plate is adhered.
4) INSTALL/REINSTALL YOUR FENDER
Separate instructions are available for the
installation of Fishbone Offroad’s Aluminum Logo
Inner Fenders on www.FishboneOffroad.com (Part#
FB33073)
5) ENJOY YOUR NEW FISHBONE OFFROAD LOGO
INNER FENDER ACCENT PLATES!
/