2. CREE LIGHTING
  3. CDR Series Goof Ring

CREE LIGHTING CDR Series Goof Ring Installation guide

  • Hello! I've reviewed the installation instructions for the Cree Lighting CDR Series Goof Ring LED Downlight. This document provides detailed steps on how to install the goof ring, safety guidelines, and specifications considering sizes for 4, 6, 8, and 10 inches downlights. I'm ready to answer any questions you have about the installation process or the device itself.
  • What is the first step of installation?
    What should I do with goof ring after opening the spring clips?
    What should I do at the final stage of installation?
CDR Series
LED Downlight
Goof Ring
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
1 of 1 LPN00687X0003A0_A
© 2021 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content
is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree® and the Cree logo are
registered trademarks of Cree, Inc.
www.creelighting.com
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant l’installation.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
INSTALLATION
STEP 1:
Open the spring clips on both sides of the lamp fixture, and insert the
goof ring into the fixture. See Figure 1.
STEP 2:
Install the goof ring into the ceiling together with thefixture. See Figure
2.
STEP 3:
Pushfixture until the spring clips are secure to the ceiling. See Figure 3
and 4.
TO INSTALL:
goof ring
1
3
2
4
Size Minimum Hole Size Maximum Hole Size
4 inches 4-3/8” (110mm) 5-15/16” (151mm)
6 inches 6-5/16” (160mm) 8-¼” (210mm)
8 inches 8-1/2” (216mm) 10-¼” (260mm)
10 inches 8-7/8” (225mm) 11-1/2” (292mm)
/