CLED INSTALLATION INSTRUCTIONS

Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.

Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com

TM

Mount the CLED to a recessed Junction Box as follows:

1. Mount the Adaptor Plate to mounting surface with

appropriate hardware.

2. Attach Tether to xture and wire the xture as shown in

the wiring section.

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding

is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A

PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.

CLED TO MOUNTING SURFACE

CLED TO JUNCTION BOX

Junction

Box

Gasket

Mount the CLED Junction Box (sold separately) as follows:

1. Mount the Junction Box to ceiling with provided

2. Attach Adaptor Plate with the screws provided.

3. Attach Tether to xture . Feed wires through the conduit

5. Use weatherproof silicone sealant between the Adaptor

CLED INSTALLATION INSTRUCTIONS

Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.

Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com

TM

or 60Hz and the following voltages:

1. Connect the black xture lead to the (+) LINE supply lead.

2. Connect the white xture lead to the (-) COMMON supply

lead.

3. Connect the bare copper Ground wire from xture to supply

ground.

Note: These instructions do not cover all details or variations in

equipment nor do they provide for every possible situation during

installation, operation or maintenance.

CLEANING & MAINTENANCE

the LED.

US: pat. D608,040; D615,689, CN: ZL201030129125.7,

ZL201030129137.X, MX: 32130, 32491, TW: pat. D139540, D139372,

CA: D RAB Lighting, Inc.

GDWPL1P Polyshield for 10W & 13W

Order 2 per CLED or “/P” for

GDWPL2P Polyshield for 20W

Order 2 per CLED or “/P” for

Sux “Y” = Warm 3000K LED

Sux “N” = Neutral 4000K LED

TROUBLESHOOTING

1. Check that the line voltage at xture is correct. Refer to

wiring directions.

2. Be sure the xture is grounded properly.

minimum. For 0-10V Dimming, follow the wiring directions as

in g. 2.

1. Connect the black xture lead to the (+) LINE supply lead.

2. Connect the white xture lead to the (-) COMMON supply

lead.

3. Connect the GROUND wire from xture to supply ground.

Do NOT connect the GROUND of the dimming xture to

the output.

4. Connect the purple xture lead to the (V+) DIM lead.

5. Connect the gray xture lead to the (V-) DIM lead.