2. iSMA CONTROLLI
  3. AG68

iSMA CONTROLLI AG68 Installation guide

  • I have read the mounting instructions for the AG68 Linkage Kit from iSMA CONTROLLI. This document provides a step by step process for assembling the device to the valve stem. I'm ready to answer any questions you might have about the mounting process or the features of this product.
  • What is the first step in mounting the linkage kit?
    What is the purpose of the open washers?
    What is the last step after lifting up the nut?
www.ismacontrolli.com
iSMA CONTROLLI S.p.A. - Via Carlo Levi 52, 16010 Sant’Olcese (GE) - Italy | [email protected]
pag. 1DIM259en | 1st Issue | 07/2022
AG68
Linkage Kit for iSMA CONTROLLI Valve with Stem d=10 mm with MVH-MVE
MOUNTING INSTRUCTIONS
• Screw the joint (1) onto the iSMA CONTROLLI valve;
• mount nut (2) on the valve stem;
• put the 2 open washers in the corresponding valve stem groove;
• lift up nut (2);
• screw stem (4) onto the nut (2);
• screw locknut (5).
/