Golden Lighting 2072-4 BLK, 2072-4 CH Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Golden Lighting 2072-4 BLK Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IMPORTANT:
• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.
• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!
• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!
PREPARING FOR INSTALLATION
PleaseNote:Thecage(P),andxturebody(R)arepre-assembled.Removeallofthecontentsfromthecarton.Seetheimportantnotes
above.Shutoffthepoweratthecircuitbreakerandcompletelyremovetheoldxturefromtheceiling,includingtheoldmountingstrap.
1.Fromthepartsbagremovethemountingstrapassembly.Oneendofnipple(F)shouldbeattachedtomountingstrap(A)withwasher
andhexnut(CandD)inplace.Theotherendshouldhavecanopyloop(H)attached.
Assembly Instructions: 2072-4 (Wesson)
For Customer Service, contact the
place of purchase.
ASSEMBLING THE FIXTURE
4.Placexturebody(R)ontoaatsurface.Rod(N)isonthexture’swires,
butnotattachedtothebodyofthexture.Passthexture’swiresthrough
rod(N)andpullthewiresuntiltaut.Twistrod(N)ontothepostatthecenter
ofthexturebody(R)untilsecure.Bymeasuring,determinethecorrect
numberofchainlinksneededforproperhangingheight.Ifnecessary,use
apairofplierstoopenandremoveanyexcesschain.Attachonechain
connector(K)toeachendofchain(J).Useoneofchainconnectors(K)to
attachchain(J)totoploop(L)andclosethechainconnector.Hooktheend
ofrod(N)ontotoploop(L).Pullthewiresthroughtoploop(L).Feedthe
xture’swiresupthroughthechain(everythreelinksorso),pullingthewires
untiltaut.Slidecanopyloopcollar(H)andcanopy(G)ontothechain/wires.
Usethefreechainconnector(K)toattachchain(J)tocanopyloop(H).
CONNECTING THE WIRES
5.Haveanassistantsupportthexture’sweightwhilecompletingthe
wiring.Cutawaytheexcesswires.Threadthexture’swiresthroughthe
canopyloopandnipple.Refertothewiringdiagramandattachthexture’s
wirestothepowersupplywiresfromthejunctionbox.
ConnectHottoHot,NeutraltoNeutral,andGroundtoGround.Twistthe
endsofthewirepairstogether,andthentwistonawireconnector.Make
surealltwistsareinthesamedirection.Ifthereisnohousegroundwire
comingfromthejunctionbox,locategroundscrew(E)onthemounting
bracket/mountingstrapandwrapthexture’sgroundwirearoundthe
groundscrew.Useascrewdrivertotightenthetopofgroundscrew(E)onto
thewiresandintothemountingbracket/mountingstrap.Tuckthewiresinto
thejunctionbox.
FINISHING THE INSTALLATION
6.Raisecanopy(G)totheceilingandslidecanopyloopcollar(I)beneaththecanopy.Tightlythreadcanopyloopcollar(I)ontocanopy
loop(H)tosecurecanopy(G)inplace.
7.Attachthehooksofrods(M)totoploop(L).Liftcage(P)sothatrods(M)andxturebody(R)isinsideofcage(P).Holdcage(P)
upandhaveanassistantattachthebottomloopsofrods(M)tothehooksinsidecage(P).Donotletgoofthecageuntilallrodsare
attachedtocage(P).
8.Installlightbulbs(notincluded)inaccordancewiththexture’sspecications.
Yourinstallationiscomplete.Turnonthepowerandtestthexture.
L
M
N
O
P
R
GND
B
D
G
I
J
K
A
E
C
F
H
JUNCTION
BOX
Q
2.Matchthethreadedholesofmountingstrap(A)tothespacingoftheholesonthejunctionbox.Attachmountingstrap(A)tothe
junctionboxusingmountingscrews(B)andascrewdriver.Tightensecurely.
3.Unscrewcanopyloopcollar(I)fromcanopyloop(H).Passcanopy(G)overthemountedcanopylooptotesttheheight.
Approximatelyhalfofthecanopyloop’sexteriorthreadsshouldbeexposed,andthecanopyloopcollarshouldtsnuglyontothe
canopyloop.Removecanopy(G)andadjusttheheightofnipple(F)andcanopyloop(H)untilthedesiredheightisreached.
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread
House Wires
Fixture Wires
Hot
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
/