Golden Lighting 2072-4 BLK Installation guide

Brand: Golden Lighting

Model: 2072-4 BLK

Type: Installation guide

This manual is also suitable for

2072-4 CH

IMPORTANT:

• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.

• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!

• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!

PREPARING FOR INSTALLATION

PleaseNote:Thecage(P),andxturebody(R)arepre-assembled.Removeallofthecontentsfromthecarton.Seetheimportantnotes

above.Shutoffthepoweratthecircuitbreakerandcompletelyremovetheoldxturefromtheceiling,includingtheoldmountingstrap.

1.Fromthepartsbagremovethemountingstrapassembly.Oneendofnipple(F)shouldbeattachedtomountingstrap(A)withwasher

andhexnut(CandD)inplace.Theotherendshouldhavecanopyloop(H)attached.

Assembly Instructions: 2072-4 (Wesson)

For Customer Service, contact the

place of purchase.

ASSEMBLING THE FIXTURE

4.Placexturebody(R)ontoaatsurface.Rod(N)isonthexture’swires,

butnotattachedtothebodyofthexture.Passthexture’swiresthrough

rod(N)andpullthewiresuntiltaut.Twistrod(N)ontothepostatthecenter

ofthexturebody(R)untilsecure.Bymeasuring,determinethecorrect

numberofchainlinksneededforproperhangingheight.Ifnecessary,use

apairofplierstoopenandremoveanyexcesschain.Attachonechain

connector(K)toeachendofchain(J).Useoneofchainconnectors(K)to

attachchain(J)totoploop(L)andclosethechainconnector.Hooktheend

ofrod(N)ontotoploop(L).Pullthewiresthroughtoploop(L).Feedthe

xture’swiresupthroughthechain(everythreelinksorso),pullingthewires

untiltaut.Slidecanopyloopcollar(H)andcanopy(G)ontothechain/wires.

Usethefreechainconnector(K)toattachchain(J)tocanopyloop(H).

CONNECTING THE WIRES

5.Haveanassistantsupportthexture’sweightwhilecompletingthe

wiring.Cutawaytheexcesswires.Threadthexture’swiresthroughthe

canopyloopandnipple.Refertothewiringdiagramandattachthexture’s

wirestothepowersupplywiresfromthejunctionbox.

ConnectHottoHot,NeutraltoNeutral,andGroundtoGround.Twistthe

endsofthewirepairstogether,andthentwistonawireconnector.Make

surealltwistsareinthesamedirection.Ifthereisnohousegroundwire

comingfromthejunctionbox,locategroundscrew(E)onthemounting

bracket/mountingstrapandwrapthexture’sgroundwirearoundthe

groundscrew.Useascrewdrivertotightenthetopofgroundscrew(E)onto

thewiresandintothemountingbracket/mountingstrap.Tuckthewiresinto

thejunctionbox.

FINISHING THE INSTALLATION

6.Raisecanopy(G)totheceilingandslidecanopyloopcollar(I)beneaththecanopy.Tightlythreadcanopyloopcollar(I)ontocanopy

loop(H)tosecurecanopy(G)inplace.

7.Attachthehooksofrods(M)totoploop(L).Liftcage(P)sothatrods(M)andxturebody(R)isinsideofcage(P).Holdcage(P)

upandhaveanassistantattachthebottomloopsofrods(M)tothehooksinsidecage(P).Donotletgoofthecageuntilallrodsare

attachedtocage(P).

8.Installlightbulbs(notincluded)inaccordancewiththexture’sspecications.

Yourinstallationiscomplete.Turnonthepowerandtestthexture.

GND

JUNCTION

BOX

2.Matchthethreadedholesofmountingstrap(A)tothespacingoftheholesonthejunctionbox.Attachmountingstrap(A)tothe

junctionboxusingmountingscrews(B)andascrewdriver.Tightensecurely.

3.Unscrewcanopyloopcollar(I)fromcanopyloop(H).Passcanopy(G)overthemountedcanopylooptotesttheheight.

Approximatelyhalfofthecanopyloop’sexteriorthreadsshouldbeexposed,andthecanopyloopcollarshouldtsnuglyontothe

canopyloop.Removecanopy(G)andadjusttheheightofnipple(F)andcanopyloop(H)untilthedesiredheightisreached.

How to Identify the Fixture’s Wires

Hot Neutral Ground

Smooth

Ribbed

Bare Metal,

Green, or

Green Inner

Thread

Black

White

Black Inner

Thread

White Inner

Thread

House Wires

Fixture Wires

Hot

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

Golden Lighting 2072-4 BLK Installation guide

Brand: Golden Lighting

Model: 2072-4 BLK

Type: Installation guide

This manual is also suitable for

2072-4 CH

Download PDF

report

Golden Lighting 2072-4 BLK Installation guide

This manual is also suitable for

Golden Lighting 2072-4 BLK Installation guide

Related papers

Other documents