Legrand Source 1 Double Duplex Power Activation - S175BLK/BRN Installation guide

Brand: Legrand

Model: Source 1 Double Duplex Power Activation - S175BLK/BRN

Type: Installation guide

Source I

Double Duplex Power Activation

Cat. No. S175BLK/BRN

INSTALLATION INSTRUCTIONS

Walker

electrical systems conform to and

should be properly grounded in compliance

with requirements of the current National Code

or codes administered by local authorities.

All electrical products may present a possible

shock or fire hazard if improperly installed or

used.Walker electrical products may bear the

mark as UL listed and/or classified and should

be installed in conformance with current local

and/or the National Electrical Code.

1. Locate center of duct runs using measure-

ments from insert markers. Determine

location of activation fitting, then core

drill a 4" [102mm] diameter hole through

the concrete to the top of the duct.

Do not drill through the raceway metal.

2. Drill 2 1/2" [64mm] diameter hole in

duct concentric with the center of the

4" [102mm] diameter hole in the concrete.

3. Install attaching ring (Cat. No. 439) using

the two locking tabs to secure it to the

duct. Locking tabs are to be secured

to the left and right sides of the duct.

4. Attach the carpet flange to the attaching

ring with four #6-32 flat head screws pro-

vided (length of screws are determined

by depth of concrete over duct).

5. Pull wires through opening in bottom

of attaching ring and wire devices in

accordance with the National Electrical

Code and any local code that applies.

6. Secure devices to carpet flange using

screws provided (orient receptacles

with neutral sides facing one another).

7. Place receptacle membrane over

receptacles and attach receptacle

plate to carpet flange with four flat

head self threading screws.

Receptacle Plate

Self Threading Screws

Receptacle Membrane

15 amp –

125V Receptacle

#6-32 x 2" [51mm] Screws

Carpet Flange

Attaching Ring

(Cat. No. 439)

Locking Tab

4" [102mm] Dia. Hole

2 1/2" [64mm] Dia. Hole

Walker Systems, Inc.

1000 Innovation Drive, Williamstown, WV 26187

IB0004 0300

Legrand Source 1 Double Duplex Power Activation - S175BLK/BRN Installation guide

Legrand Source 1 Double Duplex Power Activation - S175BLK/BRN Installation guide

Legrand Source 1 Double Duplex Power Activation - S175BLK/BRN Installation guide

Related papers

Other documents