Legrand Walkerduct/Walkerduct ProSeries Underfloor Duct Preset Adapter - S20ADP Installation guide

Type
Installation guide
Products Covered: S20ADP
1. Using a flathead screwdriver or chisel,
remove all excess concrete from the
bottom of the preset (see Figure 1).
2. Align adapter with the top opening
of the preset (see Figure 2).
3. Using a hammer, tap the adapter until
it sits flush with the bottom of the preset.
Do not trap ground wire below adapter
(see Figure 3).
4. Place four adjusting screws in the slots
in the adapter (see Figure 4).
5. Place trim flange over adapter and align
the four mounting holes in the flange to
the four adjusting screws in the adapter
(see Figure 5).
6. Tighten flange to adapter using a narrow
blade flathead screwdriver. Do not over
tighten flange. Tighten until flange is
snug to carpet or tile surface
(see Figure 6).
S20ADP
Preset Adapter
INSTALLATION INSTRUCTIONS
Walker
®
electrical systems conform to and should
be properly grounded in compliance with require-
ments of the current National Electrical Code or
codes administered by local authorities.
All electrical products may present a possible
shock or fire hazard if improperly installed or
used. Walker electrical products may bear the
mark as UL Listed and/or Classified and should
be installed in conformance with current local
and/or the National Electrical Code.
Walker Systems, Inc.
A Wiremold Company, Williamstown, WV 26187
1 000 432 0800
Figure 1
Figure 3
Figure 5
Figure 2
Figure 4
Figure 6
© Copyright 2000 The Wiremold Company All Rights Reserved.
  • Page 1 1

Legrand Walkerduct/Walkerduct ProSeries Underfloor Duct Preset Adapter - S20ADP Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI