2. Kichler Lighting
  3. 45087PNLED

Kichler Lighting 45087PNLED User manual

  • Hello! I am an AI chatbot trained to assist you with the Kichler Lighting 45087PNLED User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IMPORTANT SAFETY INSTRUCTIONS
LIGHTED BULB IS HOT!
WARNING: To reduce the risk of FIRE or INJURY TO PERSON:
• Turnoffandallowtocoolbeforereplacingbulb.
• BulbgetsHOTQUICKLY!Contactswitchonlywhenturningoff.
• DONOTremaininlightifskinfeelswarm.(Lightisintense,
maycause“sunburn”)
• DONOTlookdirectlyatlightedbulb.
• Keepmaterialsawayfrombulbthatmayburn.
• UseONLYwithwattagespeciedorlower.
• DONOTtouchbulbatanytime,useasoftcloth.Oilfromskin
maydamagebulb.
• DONOToperatexturewithmissingordamagedglass.
1) Assemblemountingscrewstobackpanusinghexnut.
2) Atthecenterofthebackpanareknockoutslots.Remove
thesetthatmatchesyouroutletbox.
3) Securethebackpantotheoutletbox.
4) Anchorthebackpantothewallusingthesetofholesat
eachendofxtureusingwoodscrews,togglebolts,plastic
anchors,etc.
5) TURN OFF POWER.
IMPORTANT:Beforeyoustart,NEVERattemptanywork
withoutshuttingofftheelectricityuntiltheworkisdone.
a) Gotothemainfuse,orcircuitbreaker,boxinyour
home.Placethemainpowerswitchinthe“OFF”
position.
b) Unscrewthefuse(s),orswitch“OFF”thecircuitbreaker
switch(s),thatcontrolthepowertothextureorroom
thatyouareworkingon.
c) Placethewallswitchinthe“OFF”position.Ifthexture
tobereplacedhasaswitchorpullchain,placethosein
the“OFF”position.
6) Connectxturegroundwiretooutletboxgroundwirewith
wireconnector.Neverconnectgroundwiretoblackorwhite
powersupplywire.
7) Makewireconnections(connectorsnotprovided).Reference
chartbelowforcorrectconnectionsandwireaccordingly.
8) Carefullypushwireconnectionsbackintooutletboxmaking
sureallconnectionsremainsecure.
9) Slipfaceplateovermountingscrewsandbackpan.
NOTE:Becertainwiresdonotgetpinchedbetween
backpanandfaceplate.
10) Securefaceplatetobackpanusingthreadedballs.
11) Insertrecommendedbulb.CAUTION: DONOTtouchbulb
withbarehands.Ifthishappens,cleanbulbwithdenatured
alcoholandalintfreecloth.
12) Slipglasssleeveoverbulb.
13) Placefrontglassinbetweenfaceplateandcurvedbar,
aligningholesinglasswithholesoninsideofbar.
14) Pushsmallrubberwashersontoballstuds.
15) Frombackofglass,threadballstudsintoholesinglassand
andcurvedbar.
16) Tightenballstudstosecureglasstobar.(DONOTover
tighten.)
17) Settopglassontopofxturealigningholesinglasswith
holesintabsonbackplate.
18) PushsmallrubberwashersontoPhillipheadscrews.
19) Fromtopofglass,threadPhillipheadscrewsintoholesin
glassandtabs.Tightenscrewstosecureglasstoxture.
(DONOTovertighten.)
20) Raisebottomglassuptoxture,aligningholesinglasswith
holesintabsonbackplate.
21) PushsmallrubberwashersontoPhillipheadscrews.
22) Frombottomofglass,threadPhillipheadscrewsintoholes
inglassandtabs.Tightenscrewstosecureglasstoxture.
(DONOTovertighten.)
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
DateIssued:1/04/13 IS-45087-CB
FACEPLATE
PLAQUEFRONTALE
INSTRUCTIONS
For Assembling and Installing Fixtures in Canada
Pour L’assemblage et L’installation Au Canada
FRONTGLASS
VERRE
BACKPAN
PANNEAUARRIÈRE
THREADEDBALL
BOULE
PHILLIPHEADSCREW
VISÀTÊTE
SMALLRUBBERWASHER
PETITERONDELLE
CAOUTCHOUTÉE
CURVEDBAR
BARRECOURBÉE
TOPGLASS
VERRESUPÉRIEUR
BOTTOMGLASS
VERREINFÉRIEUR
Page is loading ...
/