AUTOTECH 10.998.232K Installation guide

AUTOTECH
Brand
AUTOTECH
Model
10.998.232K
Type
Installation guide

This manual is also suitable for

Phone 949.240.4000 Fax 949.240.045032240-E Paseo Adelanto, San Juan Capistrano, CA 92675
AUTOTECH
Installation Instructions
Part Number: 10.998.230K; 10.998.232K
Description: SHOCK THERAPY® IGNITION WIRES, VR6
Notes:
Since they will obviously not fit within the grooves made for the stock wires, Autotech's
Shock Therapy® wires for VR6 engines use seven "T-clips" to hold the massive 10.4mm
diameter wires in position on the wire guide/engine cover. A self-tapping screw is used to
mount each clip to the cover. No drilling is required.
We have included a new, modified factory plug wire tool to use with your new Shock
Therapy® wires. The wire slot has been widened to gain clearance for the larger insulation
used.
T-Clip Installation -
Included with your wire set is 7 nylon clips: 6 dual and 1 single. Each is held to the stock
plastic wire guide with a self-tapping screw. The short screws are used in the front engine
bank's clips, the long screws in the rear bank's.
However, always use a long screw to make the hole for the clip. Once the hole is made, you
can select the proper length screw, depending on where the clip is located.
Remove your stock wires ONE-AT-A-TIME, replacing each with a new Shock Therapy® wire
before removing the next wire. This ensures that you maintain proper firing order (correct
coil terminal to plug connection).
Procedure:
1) Using the plug wire tool, remove the connector from
one of the three front spark plugs.
2) Remove the wire from the wire guide by pulling
gently upwards, and disconnect the wire from the
coil.
3) Now match the length of the old wire to a new
Shock Therapy® wire, and install the new wire.
At this point, wait until the other two wires are in
place before trying to mount any clips. Repeat this
process until all three wires for the front engine-
bank are installed.
www.autotech.com
Plug wire tool engaged on connector end.
Phone 949.240.4000 Fax 949.240.045032240-E Paseo Adelanto, San Juan Capistrano, CA 92675
4) Using one of the longer screws to make each hole,
and a shorter screw to mount, attach 3 dual and
1 single clip to the front wire guide as shown at
right. The holes can be made in the raised section
in the guide between the stock wire grooves. Note
the clip positions in the illustrations.
5) Using the remaining 3 dual clips and 3 long screws,
complete the installation for the Shock Therapy®
wires for the rear engine bank by essentially re-
peating the process used in step 3.
Close-up of typical hole position in wire guide.
Close-up view of front bank clip positions.
Completed front bank installation
Completed installation.
  • Page 1 1
  • Page 2 2

AUTOTECH 10.998.232K Installation guide

AUTOTECH
Brand
AUTOTECH
Model
10.998.232K
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents