Page is loading ...
Remove the appropriate video output board by
loosening the lower mounting screw and gently lifting
up on the BNC bracket
(c)
until the board disengages
from the motherboard connector (d) . Move the
board slightly toward the rear of the unit until it
disengages from the backplane connector (e)
. Lift
the board from the unit. Refer to diagram 2.
VM2000 Text Overlay Board 1-1
Sensormatic
SENSORVISION SYSTEMS
V IDEO M ANAGER 2000
Text Overlay Board
Installation Instructions
V8000-0750-01 Rev A
®
WARNING SHOCK HAZARD!
CAUTION
STATIC
SENSITIVE COMPONENTS!
DISCONNECT AC POWER TO
THE VM2000 CONSOLE.
FOLLOW PROPER HANDLING
PROCEDURES TO PREVENT
COMPONENT FAILURE.
Parts
The following steps are the procedures for the
installation of the Text Overlay Board:
a. left top cover
b. video output board
Refer to Diagram 3 for connecting the correct text
overlay board to the correct connectors on the video
output board and setting the appropriate jumper pins.
4.
Insert the top edge connector
(a)
on the video
output board into the backplane connector while
aligning the two bottom edge connectors (b)
with the
motherboard connectors as shown in
Diagram 4
.
5.
Shut the console OFF and uplug the power cord.1.
Remove the left top cover (a) located over the
video output board (b) as shown in diagram 1
.
2.
3.
1
2
c. BNC bracket
d. motherboard connector
e. backplane connector
a
b
Sensormatic
Sensormatic
c
e
d
Description
Qty.
Part No.
0301-0337-011PCB ASSY, VIDEO
MGR2, TEXT OVERLAY
8000-0750-01 Rev A1
VM2000 Text Overlay Board1-2
Sensormatic
SENSORVISION SYSTEMS
Installation Instructions, continued
V8000-0750-01 Rev A
®
Press down on the BNC bracket of the board until
the board is seated in the motherboard connectors
as shown by diagram 4 .
a. top edge connector
b. bottom edge connector
7.
Replace the right top cover plate and tighten the
fastening screws.
8.
Connect the video output cables to the appropriate
video output connectors.
9.
Note: If you are unsuccessful booting up the
system, then refer to the Service section of the
VM2000 Installation and Service Manual under
Boot Failures. For checking operation of the new
video inputs, refer to the User's Manual.
3
4
6. Verify that the edge connector on the video output
board is properly seated into the backplane
connector and that the bottom edge connectors are
aligned with the motherboard connectors.
Notes:
Plug in the power cord and switch the power ON to
reboot the system.
10.
OUTPUT #4 TEXT OVERLAY OUTPUT #3 TEXT OVERLAY OUTPUT #2 TEXT OVERLAY OUTPUT #1 TEXT OVERLAY
PLACE JUMPER
HERE IF NO OVERLAY
PLACE JUMPER
HERE IF NO OVERLAY
PLACE JUMPER
HERE IF NO OVERLAY
PLACE JUMPER
HERE IF NO OVERLAY
111 1
1 111
OUTPUT #1
OUTPUT #2
OUTPUT #3
OUTPUT #4
Sensormatic
a
b
8000-0750-01 Rev A1
/
