2. Triax
  3. 383230

Triax 383230 Quick Manual

  • Hello! I am an AI chatbot trained to assist you with the Triax 383230 Quick Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Example on how to use EoC Endpoint - Ethernet with PoE/WiFi
For further information
and updated manuals go to
triax.com/support
How to install EoC Endpoint
- Ethernet with PoE/WiFi
Copyright © 2017 TRIAX. All rights reserved. The TRIAX Logo and TRIAX, TRIAX Multimedia
are registered trademarks or trademarks of the TRIAX Company or its aliates.
All specications in this guide are subject to change without further notice.
TRIAX A/S | Bjørnkærvej 3 | DK-8783 Hornsyld | Denmark
Quick Guide
EoC Endpoint - Ethernet with PoE/WiFi
Model Item no.
Version ENDate
EP, WiFi/EoC/PoE, AC 383230
890904A 02/2019
Headend
TDX / TDH
Amplifier
Splitter
Splitter
Layer 3 Layer 2
Outlets
RP filter
383900
Controller 383101/103
Laptop
TV set
Portable devices
Cloud Core Router
Mandatory for the
In Touch solution
Endpoint EPC
383200
Endpoint EPE
383230
Endpoint EPC
383200
EoC solution with Endpoint (EPC & EPE)
Coax
Ethernet
WiFi
Portable devices
Switch
IPTV
Endpoint EPE
383230
8)
How to install EoC Endpoint
- Ethernet with PoE/WiFi
4)
1) 6)
2)
7)
3)
How to install EoC Endpoint
- Ethernet with PoE/WiFi
Mount the backplate by use of 2 screws.
The Endpoint must always be mounted in a vertical position, to ensure air ow
from bottom to top. The Endpoint may be turned around to allow cables to enter
from above.
Connect the Ethernet cable for the Internet connection to Ethernet port 1
Note: If the Ethernet connection does not provide “Power over Ethernet” (PoE),
then use power supply item no. 383801 (EoC PSU for Ethernet Endpoint)
Optional:
Connect the Ethernet output if required to Ethernet port 2.
This may be a PoE device, provided the Endpoint is powered from
a PoE+ compliant switch or powered by an external power supply
Attach the Endpoint to the backplate and if power supply must be used,
then plug the power supply into the wall socket
5)
Follow the on-screen steps in the GUI > Click SAVE
Wait for Endpoint to power up and log on to the WiFi SSID called TriaxSetup_xxxx
(the xxx is specic to your WiFi controller).
Scan the setup QR code with your mobile using a QR code scanner, or congure
the Endpoint through the GUI on the WiFi controller ( in ‘Network’ -> ‘Endpoints’).
Software: https://www.triax.com/products/ethernet-over-coax/eoc-controller-32-2
https://www.triax.com/products/ethernet-over-coax/eoc-controller-64-4
Mount the cover to nish the installation
/