2. Computers & electronics
  3. Networking
  4. Routers
  5. Triax
  6. 383103
383103

Triax 383103 Quick Manual

  • Hello! I am an AI chatbot trained to assist you with the Triax 383103 Quick Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
How to install EoC Controller in
an existing coax installation
Copyright © 2017 TRIAX. All rights reserved. The TRIAX Logo and TRIAX, TRIAX Multimedia
are registered trademarks or trademarks of the TRIAX Company or its aliates.
All specications in this guide are subject to change without further notice.
TRIAX A/S | Bjørnkærvej 3 | DK-8783 Hornsyld | Denmark
Quick Guide
Controller, 32/64 EoC
Model Item no.
Version ENDate
Controller, 32 EoC EP, WiFi
Controller, 64 EoC EP, WiFi
383101
383103
890900C 08/2018
Examples
on an
EoC system
For further information - and updated manuals go to
triax.com/support
Internet
modem/router
Headend, antenna
or other TV input
Coax cable from TV
output to TV in on
controller (step 3)
Coax out to
endpoints (step 2)
Ethernet patch cable
from modem/router to
controller (step 4)
How to install EoC Controller in
an existing coax installation
4)
Mount a connection cable to connect
your TV signal to the TV in port on the
controller.
Just follow the 7 steps from the GUI
to set up your EoC Controller
8)
1)
Mount the Controller in 19” rack or
on the wall with the brackets
*) Safety
Controller units must be correctly earthed
according to applicable national regulations.
5)
2)
Disconnect the output cable from
the TV signal device (shown here with
TV out from a headend)
Connect the cable to one of the EoC out
1-4 on the Controller
Note that each EoC output can support
up to 16 endpoints
6)
Connect you laptop to the EoC
controller in ethernet port 1 with
an ethernet patch cable
3) 7)
Open your browser
Type in: http://setup.eoc
Enter username and password at the
logon prompt.
Default login username/password is:
admin/admin
Remember to change this after rst
login.
How to install EoC Controller in
an existing coax installation
Now you are nished with the
conguration > click Finish and you
will see the System Status
Connect your router or internet modem
to the EoC controller with an ethernet
patch cable.
If you use the default setup
- port 2 is for a private network
- port 3 is for guest network
- port 4 is for IP TV
*) Safety
/