INSTALLATION
STEP 1
Decide where to locate the control box and
ensure wiring has enough length for light
bars to be installed in desired location.
IMPORTANT:
The control box must be installed inside the vehicle
as it is not waterproof. Avoid installation areas of
the engine bay + heated surfaces.
AUXILIARY WIRE
TM
TM
POWER SOURCE HARDWIRE HARNESS
TM
FUSE TAP
FUSE
BOX GROUND
CIGARETTE POWER ADAPTER12 VOLT CHARGING PORT
or connect the positive wire to the fuse tap and connector the open negative wire to a
ground (any metal surface). Then plug the fuse tap into the 10amp switched fuse.
IMPORTANT: Connecting to more then 10amp will override the kit and cause early
failure, ensure it is 10amps or less!
WARNING: Please ensure that the led bars or strips/control box/wiring all are
mounted in areas where will not exceed 85C or 185F.
Once connected, plug the control box Cigarette Power Adapter into an available 12 volt charging port.
IMPORTANT:
The extension wires are on the led bar. Lay
out the bars to measure the length prior to
install for a successful installation.
2 x 48” LED Bar + 8ft extension wire
1 x 36” LED Bar + 18ft extension wire
1 x 36” LED Bar + 8ft extension wire
