Essence Care@Home C7000 Getting Started

  • Hello! I am an AI chatbot trained to assist you with the Essence Care@Home C7000 Getting Started. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Care@Home
C7000 and EPP Kit
Getting Started
PERS
The Best Location for the C7000
Where speakerphone can be
heard throughout premises
Convenient for
resident to access
Good cellular
reception
Place thumb in
oval hold and lift
off the cover
Turn the power
switch on
Insert the
backup battery
Connect the power cable
and plug into a power source.
Then close the back cover
5
1
1
3
4
Setting Up the C7000
Insert the SIM
2
Insert the SIM
Press to start an
emergency call.
Red light:
Blinking: alarm in
progress
On: message
acknowledged
Press to cancel an
emergency call
Shows communication status
Green: if on, ready for call.
If blinking, message being
sent
Red: if on, communication
failure
Orange: active
conversation
Shows problem status
On: malfunction in the
C7000 or a peripheral
Blinking: supervision
lost, or low battery in a
peripheral
Shows power status
On: AC power
connected
Blinking: using
battery
Off: no power
Using the C7000
PAIRING button
© 2018 All rights reserved to Essence SmartCare Ltd.
For more information, see: http://www.essence-grp.com/resources/smart-care-download.html
Legal notice: http://www.essence-grp.com/html/concerning_documents.html
www.essence-grp.com • [email protected]
ESUG05149 Rev 1.0
Setting Up the EPP
The EPP in Action
1 2
3
Move the EPP at least 50
cm (20 in.) away from the
C7000.
Press the button.
Press the PAIRING button
for 5 seconds.
The panel beeps and the
EMERGENCY button blinks blue.
5
"
Blue
50 cm (20 in.)
Panic Button
The EPP blinks red when the panic
button is pressed or a fall is detected
The EPP lights green when
the battery is replaced
Monitoring Station
/