From underneath the worksurface,
loosen (do not remove) 2 screws
(see Fig A).
Position the parts as shown
and slide the rear basket
into slots in back
(See Fig B).
Once basket is in place, insert (4)
#10 x 3/4” screws and tighten
(See Fig. C).
From the bottom of rear basket,
take a long shafted phillips screw
driver and tighten last (2) screws
which are already fastened
in the worksurface (previously
loosened in Step 1).
1
2
62XX-501-31
9A482001
Installation Instructions
INS-9A482001 (Rev.A)
Tools required:
#2 Phillips Drive Screw driver or #2 Square bit drive
Parts Included:
(1) Rear Basket
(4) #10 x 3/4” Long Pan Head Phillips Drive Recex Screws
Fig A.
Fig C.
Fig B.
Midmark Corporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com
