APsystems 2300532 25A AC Connector EN 3-Wire Installation guide

Type
Installation guide

This manual is also suitable for

2018/1/15 Rev1.1
1
APsystems
8701 N. Mopac Expy, Ste 160, Austin, TX 78759
Tel : 844-666-7035
apsystems.com
25A AC Connector (EN,3-wire) Field Wiring
Installation Guide
(For USA)
Tools: Cross screwdriver, wire striper, solid wrench or monkey wrench .
Step 1. Verify the AC connector: Type is 25A AC Male Connector (EN,3-wire) or 25A
AC Female Connector (EN,3-wire).
Step 2. Wire Stripping
Wire gauge3x2.5mm²~4mm²(or 14AWG~12AWG)
Cable OD10mm~12mm
Wire stripping size ( mm ):Earth wire is supposed to be longer than Live wire and Neutral wire.
Step 3. Install the AC connectors
a. Set the parts on the cable according to the order of 1→2→3→4.
25A AC Male Connector(EN,3-wire)
25A AC Female Connector(EN,3-wire)
3 Seal body
4 Body
2Claw
1Nut
2018/1/15 Rev1.1
2
APsystems
8701 N. Mopac Expy, Ste 160, Austin, TX 78759
Tel : 844-666-7035
apsystems.com
b. Crimp wires: the plastic core of connector is printed, please wire according to the print,
screw twisting torque
.
NOTE:If the microinverter's output is L,N,PE, the wiring method is:
If the microinverter's output is L,L,N, the wiring method is:
① ②
Connector
Power Grid
L
L
N
N
PE
PE
c. Push Housing into Body until hear the the click sound.
d. Insert Seal and Clamp Finger into Body, then tighten the nut, torque
e. Installation of cable end female connector is the same as male connector.
Connector
Power Grid
L
L
N
L
PE
N
Installation completed
25A AC Male Connector
25A AC Female Connector
Plastic Core
click
mN 5.0/0.4
  • Page 1 1
  • Page 2 2

APsystems 2300532 25A AC Connector EN 3-Wire Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI