Tools Required:
• 1/2-inch wrench (or adjustable wrench)
Handle
Tines
Depth Stake
HandleAdjustment Crank
Clutch Lever
Using four clevis pins and four cotter pins
from the manual bag, install the labeled
tines onto the tine shaft inner tines first, then
the outer tines and exactly as shown.
Remove the remaining clevis pin and cotter
pin from the manual bag, install the wheel
assembly into the chain case bracket
Remove the two screws
from the bracket in the
chain case. Insert the
horizontal bracket into the
chain case brackets and
secure the depth stake
assembly in place with the
screws just removed
Remove the bolts, washers and nuts from
the chain case bracket. Place the handle into
position and secure with the previously removed
hardware.
Remove the handle
adjustment crank from
the handle. Rotate the
handle upward and
secure it in place with
When the handle is in place, insert the
clutch cable into the cable guide on the
handle
778-13326© 2012 21B-34M
A1
A2
B1
B2
B2 B1
A2
A1
the handle
adjustment
crank.
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Gas Cap
Throttle
Control
Starter Rope
Handle
Choke
Control
Oil Fill
Fill fuel tank with clean, fresh
gasoline until fuel reaches the fuel
level indicator.
Pour the entire contents of the
oil bottle (included in carton)
into the oil fill.
Grasp starter rope handle
and pull with quick, full-arm stroke.
When engine starts, slowly move choke
control into the Run
position.
Move throttle control into the
Fast
position.
Move the choke control
into the Choke
position.
778-13326© 2012 21B-34M
The wheels and
depth stake need
to be adjusted
to meet your tilling needs
before operation. Removing
the clevis pin from the chain
case bracket and raise the
wheels to the desired height.
Remove the clevis pin and
cotter pin place the depth
stake in the desired position
and reinstall the hardware.
Disconnect and ground the spark plug
wire against the engine. Adjust the forward
clutch cable if necessary by loosening
the hex nut. Turn the cable collar section one or
two turns to increase or decrease tension on the
cable. Retighten the lock nut against the cable collar.
Reconnect the spark plug wire.
7
10
8
11
9
12
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
/