3D Cabin 3D CAM LVL Operating instructions

www.3DCabin.co.uk

Instructions

1. Move your Motorhome/Caravan so it is in the desired level position

2. Place the two round pieces together as below and screw them to the desired

position, ensure that this position is no more that 15% from level. Tighten the screw

just enough to allow the two pieces to rotate for setting.

3. Gently slide the spirit level into the top holder clip.

4. Twist the two round pieces until the level shows in the centre position

5. Carefully while holding the two round pieces remove the spirit level by pushing it out

with a blunt object through the small hole in the back of the top clip, be careful not

to move the two round pieces.

6. Whilst keeping it held firmly tighten the screw so that no movement it likely to alter

the current setting.

7. Now gently place the level back into the housing.

8. It should now show centre level and should be tight enough to resist any gentle

knocks. Repeat the process above if you need to make further adjustments.

Download PDF