GE DR2 Installation guide

Brand: GE

Model: DR2

Type: Installation guide

GE DR2 LED traffic signal lamps, designed for durability and energy efficiency, provide reliable illumination for traffic intersections. Engineered to meet strict traffic signal standards, these lamps offer enhanced visibility and long-lasting performance in various weather conditions. With simple installation and low maintenance requirements, GE DR2 LED lamps are an ideal choice for municipalities and transportation authorities seeking to upgrade their traffic signal infrastructure.

Installation Instructions

DR2 LED Traffic Signal Lamps

100mm (Circular modules)

Installation Steps:

1. Verify input voltage is 120V or 230V nominal, as indicated on the label at the back of the LED

signal module, before installation. Failure to do so will cause lamp to fail.

2. Open front cover of (customer supplied) traffic signal housing.

3. Remove outer lens and incandescent bulb from traffic signal housing OR existing LED signal

module. Retain all hardware as removed as it may be needed in subsequent steps.

NOTE: Installer is responsible for ensuring the disposal of removed components complies with all

applicable regulatory requirements

4. Ensure that appropriate adaptor ring is installed on the lamp. Refer to TRAF139 for installation

instructions of adaptors with lamp.

5. Insert the LED signal module into the available cavity from previous LED module or front lens.

NOTE: Ensure that the arrow ’’’’ on the back cover of the LED signal module is oriented in the

desired position of the aspect.

6. Install mounting hardware to ensure that the LED signal module is securely fastened to traffic

signal door.

7. Ensure that the wires are securely connected to the terminal blocks for proper operation.

NOTE: Either wire could be connected to either terminal block.

8. After installation of all modules is complete, ensure all traffic signal housings are closed and

secured properly.

9. Apply power and ensure proper operation of traffic signal modules per intersection requirements

as specified by customer.

Up arrow (



)

Risk of Electric Shock

Install unit in enclosure tested

to be suitable for wet locations

only.

Prepare Electrical Wiring

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Electrical Requirements

 Do not use in wet locations

 Follow all National Electric Codes

(NEC) and local codes.

GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com

1 - 8 8 8 - 6 9 - 4 3 - 5 3 3 • or • +1.216.266.2419

GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand and logo are trademarks of the General Electric Company.

conditions.

TRAF138-R120110

Voltage Rating

120V or 230V nominal

GE DR2 Installation guide

GE DR2 Installation guide

Related papers

Other documents