7409-K330
Bar Code Scanner
Kit Instructions
Issue A
Revision Record
Issue Date Remarks
A Aug 2011 First issue
1
Introduction
This kit provides a Bar Code Scanner for the following terminals.
NCR RealPOS 25 (7610)
NCR RealPOS 50 (7611)
The assembly installs on the bottom of the terminal.
7409-K330 Bar Code Scanner
2
Components
Cable Cover Lock Plate
497-0473132
7610 Cable Cover
497-0473300
MS3207 Scanner Cable, Db9 to USB
497-0466203
Screw, M3 x 0.5 x 6 mm, FH
006-8612557
Screw, 6-32 x 5/16, Phillips, FH
006-8611269
MS4980 Scanner Bracket
497-0473130
MS3207-1000 MiniScan
006-8612581
3
Installation Procedures
1. Unplug the terminal power cord and turn off the power to any connected
peripheral devices.
2. Remove the terminal Cable Cover.
3. Connect the scanner cable to a USB Connector on the I/O Panel.
USB AUSB B
4
4. Install the Scanner Assembly onto the bottom of the terminal. There are no
fasteners, the plastic Cable Cover snaps into position on the terminal Rear Cover.
/
