Insert tube stiffener with chemical tubing into
corresponding chemical dispensers.
5
STEP
BLUE RED
WHITE
1
STEP
Connect 110/120V, 60HZ hard wired power
supply to power box. DO NOT USE POWER
CORD OR GFI OUTLET.
L -1X16 / L -1X
Quick Setup
Instructions
ELECTRICAL
CONNECTION
1
TUBE
STIFFENER
5
CHEMICAL
TUBING
5
DRAIN HOSE
CONNECTION
4
1/2" WATER INLET
2
LEVELING LEGS
3
Connect the drain hose to wall or floor drain.
The floor drain must have a 1 inch air gap
between drain hose and floor drain.
WALL DRAIN
FLOOR DRAIN
1"AIR GAP
4
STEP
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
11-2016
REAR VIEW
HOT
NEUTRAL
GROUND
Connect dishmachine to hot water source
recommended 140
0
temperature (120
0
minimum temperature required).
STEP
2
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back to
ensure proper performance.
3
STEP
L-1X16 LEG
ADJUSTER
L-1X LEG
ADJUSTER
PN: 10130.11