GL-C

CMA Dishmachines GL-C Quick Installation Guide

  • Hello! I am an AI chatbot trained to assist you with the CMA Dishmachines GL-C Quick Installation Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • Who can connect electrical and plumbing equipment?
    What is required to level the dishmachine?
    How is the water level set?
    How do you prime chemical dispensers?
    What should the wash temperature be?
    How do you start the conveyor?
CONCENTRATION
DETERGENT
CONCENTRATION
RINSE
CONCENTRATION
SANI
HEATER THERMOSTAT
11-2017
POWER BLOCK
1
POWER SWITCH
5
6
THERMOMETER
DRAIN CONNECTION
3
GL-C Carousel
Glasswasher
Quick Setup
Instructions
LEVELING LEGS
4
HOT WATER
INLET
2
COLD WATER
INLET
2
1
STEP
Connect the drain hose to the FLOOR DRAIN. If
floor drain is not available connect to the wall. Floor
drain must have a (1 inch) air gap between the drain
hose and the floor drain.
Adjust heater thermostat to 140F.
Connect water lines (hot 140F/160F) and (cold
75F) to water solenoid valves.
Flip power "on-off/flush" switch to "ON" position.
Wash tank will automatically fill.
Connect L1 and L2 leads to the power block
ground wire to ground lug.
4
STEP
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back to
ensure proper performance.
GROUND
L2
L1
2
STEP
6
STEP
140
3
STEP
FLOOR
DRAIN
1"AIR GAP
WALL
DRAIN
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
6
5
STEP
CONCENTRATION
DETERGENT
CONCENTRATION
RINSE
CONCENTRATION
SANI
PN: 10130.37
CONCENTRATION
DETERGENT
CONCENTRATION
RINSE
CONCENTRATION
SANI
PRIME
DETERGENT
CONCENTRATION
PRIME
SANITIZER
CONCENTRATION
PRIME
RINSE
CONCENTRATION
FLUSH
OFF
ON
CONCENTRATION
DETERGENT
CONCENTRATION
RINSE
CONCENTRATION
SANI
11-2017
10
STEP
Start conveyor by flipping rocker switch to
"ON" position.
CHEMICAL
STORAGE AREA
ROCKER
SWITCH
10
TUBE
STIFFENER
8
CHEMICAL
TUBING
8
OVERFLOW
DRAIN TUBE
PRIMER
PUSH BUTTONS
AUTO FILL TIMER
7
9
7
STEP
6
5
4
10
1
9
3
2
8
7
INPUT
INIT.
MAX
MIN
LOAD
3
2
1
72
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply with
all Federal, State and Local Health,
Electrical, Plumbing and Safety codes.
GL-C Carousel
Glasswasher
Quick Setup
Instructions
The Spirit of Excellence
an Ali Group Company
Insert tube stiffener with chemical tubing into
corresponding chemical dispensers.
8
STEP
BLUE RED
WHITE
Push each of the chemical prime buttons and
hold until the chemical feed tubes are full.
9
STEP
CONCENTRATION
DETERGENT
CONCENTRATION
RINSE
CONCENTRATION
SANI
Adjust auto-fill timer to 10 seconds to set
water level.
PN: 10130.37
/