Noble House 294946 User guide

Brand
Noble House
Model
294946
Type
User guide

This manual is also suitable for

CAUTION : This table is NOT a TOY.
Keep your child / children at bay in the process of assembly.
Assembly Instructions
Caution : You must read this before you proceed.
CAST TABLE
1 OF 5
No. Picture Description Qty
A
Table Top 1
B
Leg Support Panels 4
C
Table Legs 4
No. Picture Description Qty
D
Studs(M8*40mm）
14
Washers ( 8mm ) 14
Springs Washers ( 8mm) 14
Nuts ( 8mm ) 14
J
Screwdriver 1
K
Spanner 1
E
Before Beginning Assembly:
2 OF 5
Place the Table Top(A) with the underside facing skywards.
Fit the Studs(D) by turning into the 4 points on the underside of Table Top(A) with the
Screwdriver(J).
DO NOT tighten, yet.
Step 3
Step 2
Step 1
Unpack and place all parts on a clean soft surface.
Note : It is recommended that you have a partner to assist in the assembly process.
Next, place and fit the four Table Legs (C) over the Studs previously fitted in Step 2 with
Washers, Spring Washers and Nuts((E) using the Spanner(K) .
DO NOT tighten, yet.
3 OF 5
Step 5
Turn the table right side up.
Adjust the pre-installed Levellers at the end of each table leg until the table is level with the
ground.
Securely, tighten and fasten all the screws and washer-nuts.
Your table is now ready for use.
Step 4
NOTE : To HOLD the legs together in positon, the LEGS SUPPORT PANELS WILL
OVERLAP AT ALL 04 (four) CORNERs.
Fit the Studs(D) into the Legs(C)with the Screwdriver(J).
First, put the Leg Support(B) mark 1# and then attach the other end mark 2# Support Panel,
together.
Then affix the Leg Support(B) to the table legs with the Washers, Spring Washers and
Nuts(E).
DO NOT tighten, yet
Repeat the same process for all 04 (four) contact points of the Table Legs and the Legs
Support Panels.
Once all the panels are in place, proceed to TIGHTEN the screw-bolts of the legs, in a
rotational sequential manner.
By this action, it allows the table legs to be locked into position, evenly, thus reducing
wobbles.
Thereafter, lock all the Leg Support Panels tightly into position.
(*Leg Support Panel has 02 wings.One wing is of a SLOPED wing and the other
DENTED wing.
The SLOPED wing is marked 1#. The DENTED wing is 2#. The Sloped Wing 1# is to be
on top and overlapped over the Dented 2# wing at assembly.)
4 OF 5
5 OF 5
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Noble House 294946 User guide

Brand
Noble House
Model
294946
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents