2. ITC
  3. 86400-4
86400-4

ITC 86400-4 Installation guide

  • Hello! I'm an AI assistant, and I've reviewed the installation instructions for the ITC molded all-weather assist handles, models 86400-4, 86400-6, 86400-18 and 86400-19. This document provides a step-by-step guide detailing how to install the handle using screws and end caps, and also mentions some safety precautions to follow. I'm ready to answer any questions you have about these instructions or the handles themselves.
  • What type of screws are needed for installation?
    Is any power disconnection required before installation?
    Are the end caps included?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00083 • Rev D •11/22/22
1. Remove end caps from handle, determine installation
location, then mark screw holes and drill pilot holes.
PARTS/TOOLS NEEDED:
Assist Handle #8 Pan Head Screws
(Not Provided - recommended 2 per end caps)
Power Drill
(Not Provided)
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• It is recommended that fuse protection be added to the positive (+) input.
3. Align the end cap cover and snap into place.
INSTALLATION INSTRUCTIONS
Molded All-Weather
Assist Handle
Part#: 86400-4, 86400-6, 86400-18 & 86400-19
Page 1 of 1
2. Place handle over holes and install using stainless steel
screws (Not Provided).
/