Hagerco 3400 Series Lever - Grade 1 Cylindrical Lever, 3495 Intruder Classroom Lockset Lever - Grade 1 Cylindrical Lever Operating instructions

Hello! I am an AI chatbot trained to assist you with the Hagerco 3400 Series Lever - Grade 1 Cylindrical Lever Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

SFIC TIMING INSTRUCTIONS

3495 INTRUDER CLASSROOM

I-LS02383

Rev -, Rev Date: 02/06/2019 27390103 Page 1 of 2

Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com

INTERIOR EXTERIOR

DOOR HANDING: RH/RHR

STEP 1: Using a flat blade screwdriver, orient the cams in the lock chassis as shown below

EXTERIOR

STEP 2: Orient the tailpieces in the mating spring cages to match the cams above. Install the exterior spring cage first, followed by the

interior spring cage, lining up the cams and tailpieces so they mate together. Do not force the fit.

SFIC FORKS MUST BE

ORIENTED AS SHOWN

FINGER SHOULD BE

VISIBLE AS SHOWN

STEP 3: Install SFIC Cores in both levers

VERIFY INSTALLATION: Using the keys, check the lock timing. The lock is properly timed if the key rotates 360° to lock and unlock the door.

INTERIOR

FINGER SHOULD BE

VISIBLE AS SHOWN

SFIC TIMING INSTRUCTIONS

3495 INTRUDER CLASSROOM

I-LS02383

Rev -, Rev Date: 02/06/2019 27390103 Page 2 of 2

Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com

DOOR HANDING: LH/LHR

STEP 1: Using a flat blade screwdriver, orient the cams in the lock chassis as shown below

EXTERIOR INTERIOR

FINGER SHOULD BE

VISIBLE AS SHOWN

FINGER SHOULD BE

VISIBLE AS SHOWN

EXTERIOR INTERIOR

STEP 3: Install SFIC Cores in both levers

VERIFY INSTALLATION: Using the keys, check the lock timing. The lock is properly timed if the key rotates 360° to lock and unlock the door.

SFIC FORKS MUST BE

ORIENTED AS SHOWN

STEP 2: Orient the tailpieces in the mating spring cages to match the cams above. Install the exterior spring cage first, followed by the

interior spring cage, lining up the cams and tailpieces so they mate together. Do not force the fit.