• Thispowersupplyisforusewithlandscapelightingsystemsonly.

• Donotsubmergetransformer.

• Thisdeviceisacceptedasacomponentofalandscapelightingsystem

 wherethesuitabilityofthecombinationshallbedeterminedbyCSAor

 localauthoritieshavingjurisdiction.TocomplywithCSArequirement,this

 xtureshouldbeinstalledbyaqualiedelectrician.AuCanada.Pourêtre

 enaccordavecIES1015CSA.Celuminairedoitêtreinstalléparun

 électricienqualié.

• WARNING:Riskofelectricshock,useonlywithlowvoltagelandscape

• Transformershouldbemountedclosetopowersupply.Extensioncords

 shouldnotbeusedwiththisunit.

• WARNING:(forPowerSupplyCordconnectedPOWERUNIT)

 RISK OF ELECTRIC SHOCK.Installpowerunit5feet(1.5m)ormore

 fromthepool,spa,orfountainwherethepowerunitisinstalled(a)

 indoorwithin10feet(3.0m)ofapool,spa,orfountain,or(b)outdoor,

 connectpowertounittoareceptacleprotectedbyaGFCI.

• Thisoutdoorpowerunitshallbeconnectedtoa115/120voltcoveredGFCI

 receptaclemarked“WetLocation”whileinuse.

• Mounttherain-tighttransformeratleastonefootabovegroundlevelwith

®

landscapedistributor.

 •8GAwirecanbepurchasedinlengthof250’(76M),15503-BK.

 •10GAwirecanbepurchasedinlengthof250’(76M),15504-BK.

 •12GAwirecanbepurchasedinlengthsof100’(30M),15501-BK;250’

  (76M),15502-BK;500’(152M),15505-BK;and1000’(304M),15506-BK.

• FindingTransformerLoad:Lowvoltagesystemsrequiretheuseofa

 transformertoreducestandard120-VOLTpowerfromyourhometo

 12-VOLTS.Todeterminethetransformersizeyouwillneed,addupthe

 wattagesofalllampsyouplantouse.Selectatransformerthatmatches

 transformer.

ThisinstructionsheetcoverstheinstallationofthefollowingKichler®Transformers:15510AZT,15513AZT,15514AZT,15M200AZT,

15T200AZT,15TP200AZT.Readtheseinstructionscarefullybeforeinstallingthisunit.

INSTALLATION INSTRUCTIONS

1) Determinedesiredlocationformountingtransformer.NOTE:When

 decidinglocationformountingconsiderationshouldbetakenforthe

 requirementslistedabove.

2) Markpositionoftopportionofthekeyholeslotlocationattopoftransformer

 andtheslotlocatedatbottom.

3) Ifmountingtoasolidsurfacesuchaswood,siding,etc;

4) Sliplargeportionofkeyholeoverheadoftopscrewandallowtransformer

 toslidedown,makingsurebottomslotisbehindheadofbottomscrew.

5) Tightenscrewsuntiltransformerissecure.

6) Split12/2.10/2,or8/2cableapproximately3”,andstrip1/2”insulation

 offeachwire.12/2.10/2,and8/2cableistheheavyblackcablewhich

 allKichler

®

12-voltlowvoltagelightingxtureswillbeconnected.(Reference

 abovefordescriptionandpartnumbers).

7) Pushonebarewireineachoftheholesonthebottomsideoftheterminal

 blockandtightenscrewsonthefaceoftheterminalblockuntilwiresare

We Warrant our transformers for ten years on aZt units and lifetime on stainless steel units against defects in material and Workmanship if it is prop-

erly installed and failed under normal operating conditions, provided it is returned to the point of purchase, Where it Will be repaired or, as it may be

determined, to replace the transformer.

INSTALL AND MAINTAIN TO MEET APPLICABLE CODES

  functionbutwillnotactivatesystem

  duringpresettimes.

HI: Useifthetransformerisfully

  loaded(maximumwattage

  capacity),cabledistancesare

  longorifthestartingvoltageis

  lowcomingfromthehouse.

The“HI”or“LOW”position

switchwillactivateboth

thetimerandphotocell

NOTE: TIMER INSTRUCTIONS LOCATED ON INSIDE OF

TRANSFORMER COvER.