Selection of the block size for the restoration is automatically
determined upon completion of all of the design steps required
of the restoration. You will be prompted by the CEREC machine
to insert a block corresponding to the size. Proceed with the
following size guidelines.
Paradigm MZ100 block is made in two cylindrical sizes —
10 and 14; these correspond to the CEREC sizes according
to the following conversions:
Paradigm
™
MZ100
Block for CEREC,
Sizes 14 and 10
Milling Lubricant
Either Sirona
™
Dentatec
™
or Sirona
™
Dentatec ProCAD CEREC
Milling Concentrate can be used with Paradigm MZ100 blocks.
The recommended level of concentrate 50 to 75 ml can be used.
It is important to change the water as indicated by the CEREC
software.
Finishing/Polishing and Characterization
Finish occlusal surface using an appropriate finishing
instrument. Finish proximal surfaces with 3M ESPE’s Sof-Lex
™
Pop-on
™
Extra Thin Discs and Sof-Lex
™
Strips.
Paradigm
™
M Z100 Block for CEREC
®
Corresponding Sizes
CEREC
I8, I10
I12, I14,
V5-12,
V7, K14
3M ESPE
10
14
3M ESPE Customer Care 1-800-634-2249
Please refer to instructions for more detailed information 44-0007-4457-1
as well as precautionary and warranty information. © 2006 3M
3M, ESPE and Paradigm are trademarks of 3M or 3M ESPE AG.
SIZE CONVERSION AND FLUID
RECOMMENDATIONS