SMITH SYSTEM 179824 Assembly Instructions

Brand
SMITH SYSTEM
Model
179824
Type
Assembly Instructions
Table Top (1)
Connector Bolt (4)
Allen Wrench (2)
Adjustable
PSD-Legs (2)
Back Panel (1)
3/8" - 16 Dog Nut Screw (4)
#10 Wood Screws (25)
(located in each PSD-Leg, 2 per leg)
Step 1. Place table top on a smooth clean
surface laminate face down.
Step 2. Loosely attach the back panel to the
legs using the (4) connector bolts and
Allen wrench provided. (Finger Tight)
(See drawing 1B)
Step 3. Align the legs to the pilot holes on
the table top and use (12) #10 wood
screws to loosely attach the legs to
top. (See Drawing 1A).
Step 4. Now loosely attach the panel to the
table top by using (3) #10 wood
screws and supplied drill bit
extention.
Step 5. Now go back to step 2-4 and tighten
all screws to secure the legs to the
table top. Using the extended drill
bit secure the back panel to the top.
Tighten connector bolts
DO NOT OVER TORQUE SCREWS!
Step 6. Once the legs are securely attached
adjust the legs to the desired height
using the Allen Wrench provided.
(See Drawing 1C).
Drill Extension (1)
Drawing 1A
Drawing 1C
Drawing 1A
Drawing 1B
Corner Planner Lab Quick Installation Guide
Model 24600
Required for Installation
Instructions
Rev. 9/2006 Form # 179824
  • Page 1 1

SMITH SYSTEM 179824 Assembly Instructions

Brand
SMITH SYSTEM
Model
179824
Type
Assembly Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents