2. BLOTZ
  3. B20-ME-205

BLOTZ B20-ME-205, B20_ME_205, B28-ME-205 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Ancient City Walls, models B20-ME-205 and B28-ME-205. This document provides step-by-step guidance on assembling a 30-degree corner section of these city walls, emphasizing the use of PVA glue, a modelling knife and the provided parts. I'm ready to help with any questions you have about the assembly or its components.
  • What type of glue is required for assembly?
    What tools are needed to remove parts from the sprue?
    Can I use sandpaper during the construction?
    Are there different versions of this kit?
20mm / 28mm Ancient City Walls – 30 Degree Corner
B20-ME-205 / B28-ME-205
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The images here show the 20mm version of this kit, but the 28mm version is constructed in exactly the same way.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports – the
wider connectors being the ones closest together.
Take the base , rear wall pieces and additional
supports.
Glue all the supports to the rear wall, then attach
the whole assembly to the base (see pic).
Add the walkway section, gently slotting each lug
into the corresponding hole.
The front wall pieces.
Add the wall pieces
Then attach the long strips.
The finished model.
/