2. BLOTZ
  3. B20-ME-211

BLOTZ B20-ME-211, B20_ME_211, B28-ME-211 Assembly Instructions

  • I've reviewed the instructions for the BLOTZ Ancient City Wall Internal Corner models B20-ME-211 and B28-ME-211. This document provides step-by-step guidance on assembling the laser-cut wooden pieces using glue. The instructions cover all key steps, from preparing the pieces to adding the final details. I'm ready to answer any questions you have about the construction process.
  • What type of glue is required for assembly?
    What tool is required to remove pieces from the sprue?
    Is the 28mm version assembled differently than the 20mm version?
20mm/28mm Ancient City Walls – Internal Corner (30 deg)
B20-ME-211 / B28-ME-211
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The images here show the 20mm version of this kit, but the 28mm version is constructed in exactly the same way.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports – the
wider connectors being the ones closest together.
Take the base and rear wall.
Glue the supports to the rear wall (see pic).
Attach the whole assembly to the base
Add the walkway.
The front wall pieces.
Attach them to the model.
Attach the long strips.
/