AuthenTeak Kingsley-Bate Ipanema Coffee Table IP47 Assembly Instructions

Brand
AuthenTeak
Model
Kingsley-Bate Ipanema Coffee Table IP47
Type
Assembly Instructions
Kingsley-Bate
IP47 Ipanema Coffee Table
Assembly Instructions
KINGSLEY-BATE
Fine Garden Furniture
0
ASSEMBLY INSTRUCTIONS FOR THE IP-47
LEGS TABLE TOP LEGS
1
STEP-I
Unpack, inspect and lay the parts
on a clean, flat, soft surface to
avoid marring the wood.
NOTE: During assem bly of the
furniture please m atch the LEG
holes with the corresponding letters or numbers stamped on the apron of the TABLE TOP.
STEP-II
Fit the LEGS onto the corresponding holes of the
TABLE TOP as seen in the photographs.
STEP-III
Secure the LEGS with the bolts
provided (see “HARDWARE”). All
bolts can be tightened by using the
allen keys provided from both side.
STEP-IV
Place the BRACKET to the LEG with washer between
them, and the BRACKET to the TABLE TOP as shown
in the assembly photographs.
STEP- V
Secure the BRACKET to the TABLE TOP with the
small bolt and tighten with the allen key provided.
STEP- VI
Secure the BRACKET to the LEG with the long bolt and
tighten with the allen key provided.
**We recommend that two people upright the
table.**
2
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
3
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: 703-361-7000, Fax: 703-361-7001
  • Page 1 1
  • Page 2 2
  • Page 3 3

AuthenTeak Kingsley-Bate Ipanema Coffee Table IP47 Assembly Instructions

Brand
AuthenTeak
Model
Kingsley-Bate Ipanema Coffee Table IP47
Type
Assembly Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents