AuthenTeak Kingsley-Bate MT14 Assembly Instructions

Brand
AuthenTeak
Model
Kingsley-Bate MT14
Type
Assembly Instructions
Kingsley-Bate
MT14 Monterey Folding Side Chair
Assembly Instructions
KINGSLEY–BATE
Fine Garden Furniture
0
ASSEMBLY INSTRUCTIONS FOR THE MT-14/15
STEP-I
Unpack, inspect and lay the chair on a clean, flat, soft
surface to avoid marring the wood.
STEP-II
Up right the chair and lowe r the seat into position by
pulling out on the front of the seat.
STEP-III
Pull out the locking pin and push the seat down until it
falls into place. Release the locking pin, making sure that
it drops into the predrilled hole in the brass hardware.
Using this chair with the locking pin out of position m ay
cause damage to the seat. Please make sure locking pin
is always locked in place before attempting to sit in the chair.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
1
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: 703-361-7000, Fax: 703-361-7001
  • Page 1 1
  • Page 2 2

AuthenTeak Kingsley-Bate MT14 Assembly Instructions

Brand
AuthenTeak
Model
Kingsley-Bate MT14
Type
Assembly Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents