AuthenTeak Kingsley-Bate TB35 Assembly Instructions

Brand
AuthenTeak
Model
Kingsley-Bate TB35
Type
Assembly Instructions
Kingsley-Bate
TB35 Tiburon Rectangular Bar Table
Assembly Instructions
KINGSLEY–BATE
Fine Garden Furniture
0
ASSEMBLY INSTRUCTIONS FOR THE TB–35
RIGHT END FRAME TABLE TOP LEFT END FRAME
STEP-I
Unpack, inspect and lay the parts on a
clean, flat, soft surface to avoid
marring the wood.
HARDWARE
STEP-II
Gently lay the TABLE TOP face down on a clean,
flat, soft surface. Loosely attach RIGHT END
FRAME to TABLE TOP as shown in the
photographs (use short bolts to attach by hand. Do
not tighten all the way). Attach LEFT END FRAME same as above.
STEP-III
Carefully line up the LEG
STRETCHERS to the END
FRAME stretcher bar as shown
in the photographs and insert
the long bolts from the outside of the fram e. Secure all four bolts by hand as far as they will
go.
STEP-IV
All knock down bolts can now be tightened by
using the allen key provide d. Carefully upright
table.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOUR OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
1
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: 703-361-7000, Fax: 703-361-7001
  • Page 1 1
  • Page 2 2

AuthenTeak Kingsley-Bate TB35 Assembly Instructions

Brand
AuthenTeak
Model
Kingsley-Bate TB35
Type
Assembly Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents