home store more 132617 User manual

Hello! I've reviewed the assembly instructions for the Floor Lamp models 132617 and 132618. This document includes a parts list and step-by-step instructions on how to safely assemble your new floor lamp. It also mentions key safety warnings and proper usage for the device. I understand the importance of following guidelines to avoid damage. Feel free to ask any questions you have about the assembly process or the device's features.
What should I do with the plastic rings?

What is the maximum wattage of the bulb?

Is this lamp suitable for outdoor use?

What kind of bulb does it use?

①

.Remove plastic ring ( Part I ) from the metal tube.

IMPORTANT NOTICE:

This plastic ring protects cable avoiding being damaged

during transportation, please throw them away, and keep

out of reach of children

Be careful not to twist or damage power cord when

assembling the light.

②.According to the assembly sequence,

Screw part D into part E and tighten.

③.Screw part E into Part F, and tighten

④.Screw part F into Part G, and tighten

⑤

.Screw part G into Part H, and tighten

ES MAX 42W (Bulb not included)

The wattage indicated must not be exceeded.

Warnings

* Ensure the plug is not connected to any power supply and read instructions before assembly.

*To avoid the risk of fire, do not exceed the recommended wattage of bulbs as indicated on the fitting.

*Ensure the floor lamp is placed on a stable, solid surface and under no circumstances must it be

covered with any material

*The shade and lamp may become very hot in use. Switch off and allow 10 minutes to cool before

replacing bulb, adjusting, or cleaning (using a dry cloth only – do not use liquid or abrasive cleaners).

*The assembly of this floor lamp is not suitable for persons under 18 years of age. Keep small parts out

of reach of children.

*This lamp is for indoor use only.

132617 & 132618

I. Metal tube protection plastic ring X 3

C. E27 Lampholder X 1

D. Lamp base X 1

E. Lamp base metal tube X 1

F. Lamp base metal tube X 1

G. Lamp base metal tube X 1

H. Metal plinth X 1

B. Lampshde X 1

ASSEMBLY INSTRUCTIONS

Item NO.:

PARTS LIST

A. Lampholder plastic ring X 1

Carefully remove all parts from the box and lay on a flat surface.

Note: Electrical wire is connected continuously through the

poles.

Please DO NOT pull the wire during unpacking, it could lead to

poor connectivity.

To fit the shade: Remove the shade ring (A) from lamp holder

(C) and fit the shade (B). Position the shade over the lamp holder

and refit the shade ring to secure in place. Take care not to over-

tighten as may cause damage to the fitting.

/

Other documents