2. OPT7
  3. JT-LED
JT-LED

OPT7 JT-LED User manual

  • Hello! I've reviewed the user manual for the OPT7 LED Side Marker designed for the 18-22 Jeep Wrangler JL and Gladiator JT. This document provides detailed instructions on how to install the amber/white LED side markers, including guidance on wiring and ensuring proper function. It also includes product specifications and important warnings. I'm ready to answer any questions you might have regarding the installation or features of this product.
  • What is the waterproof rating of the side marker?
    What vehicles is this product designed for?
    What kind of turn signal does this side marker have?
LED
FOR 18-22 JEEP WRANGLER JL
/ GLADIATOR JT
SIDE
MARKER
AMBER/WHITE
ACC
OFF
Voltage
Waterproof Rating
Shell Color
Shell Size
Wire Length
Packaging Dimensions
12V
IP67
Silver Plated
(L)9.84*(W)5.31*(H)0.57 inch
39.37± 0.5 inch
(L)13*(W)12.2*(H)1.85 inch
PRODUCT
SPECFICATIONS
RUNNING
LIGHT
TURN SIGNAL
W/ SEQUENTIAL
Please carefully check the product for any appearance or
functional defects before you start installation
First, you need to remove the fender
from your vehicle by releasing the
bolts/fasteners inside the wheel well
as shown in Figure 1.
INSTALLATION
IMPORTANT
STEP 1
Use plastic removal tool to pry o the
air vent cover as shown in Figure 2.
STEP 2
Please thoroughly clean the painted
surface around the air vent with
isopropyl alcohol ( rubbing alcohol ) to
remove dust or residue that may inhibit
tape bonding as shown in Figure 3.
STEP 3
AIR VENT COVER
Tear o the 3M tape on the back of the
side marker lights and route the
electrical harness through the upper
channel.
Next, simply snap it in and press gently
to make sure it's firmly in place as
shown in Figure 4.
STEP 4
Now, please connect the electronic wiring
harness of the side marker lights to the
factory wiring harness separately (Refer to
wiring diagram below).
Then, Power-ON to test and make sure all
signal functions are working properly.
STEP 5
Let’s repeat the same steps on
the Passenger Side.
STEP 6
WIRE
COLOR
6
5
4
3
2
1
BG
BN
WH
GN BK BK
GN
BK
RD
WH
BN
WH
YE
Function Side
Marker Turn Ground GroundParking DRL
1 2 3 4 5 6
TAPE
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this
product. The Installation Guide is intended as assistance to reduce setup time.
OPT7 Lighting assumes no responsibility for improper installation. If you are
unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please
seek professional assistance.
/