2. Garth
  3. Manifold
Manifold

Garth Manifold Operating instructions

  • Hello! I've reviewed the user manual for the manifold Set. This document provides detailed instructions for replacing the manifold. The manual covers steps from removing the side burner ignition wire and bolts, to loosening screws and removing the panel and finally manifold itself and replacing it. I'm ready to answer your questions about the manifold replacement.
  • What is the first step in replacing the manifold set?
    How many bolts need to be removed from each side of the side burner shelf?
    What should you pay attention to when installing the fascia?
How to replace the manifold Set
Step 1: Pull out the side burner ignition wire.
Step 2: Take out the three bolts on either side of the side burner shelf, as shown.
Step 3: Loosen the front fixing screws 3mm on either side of the side burner shelf
as shown in the circles below.
Step 4: Fold open the left side table
Step 5: Take out the 3 screws on the left side shelf, as shown below in the circles.
Step 6: Loosen the front fixing screws 3mm on the left side shelf, as circles show.
Step 7: Fold open the left side table
Step 8:Loosen the two sets of screws in the sides of the panel。
Step 9: Take out all the knobs.
Step 10: Remove all screws from the knob bezel.
Step 11: Loosen the set screws at the back of the panel
Step 12: Remove the panel
Step 13: Loosen the side furnace bellows and pressure relief valves.
Step 14:
A. Replace with a new manifold and conduct a leak test.
B. Reverse steps above to install the parts back. Please pay attention when
installing the fascia to ensure that each injector on the manifold aims at the
burner inlets.
/