1
Form: BMS-1034
Rev. A
For further information, scan
this QR code or visit
www.bimba.com
Product Instructions
Hydraulic Shock Absorber
LS, SS, and HS Series
MODELS
USABLE STROKE
(INCHES) (mm)
LS-02 .25 6.4
SS-02 .25 6.4
HS-02 .25 6.4
LS-04 .41 10.0
SS-04 .41 10.0
HS-04 .41 10.0
LS-09 .63 16.0
SS-09 .63 16.0
HS-09 .63 16.0
LS-17 .88 22.0
SS-17 .88 22.0
HS-17 .88 22.0
LS-31 1.56 40.0
SS-31 1.56 40.0
HS-31 1.56 40.0
CAUTION:
A. Only the usable stroke listed above should be used. If the full stroke is used, undesirable bottoming will occur
against the positive stop. It is, therefore, important to position the shock absorber such that only the usable
stroke is used. Stop collars are available to prevent the shock absorber from bottoming. They also ensure
that work being positioned is stopped at the same point every time.
B. If shocks are used at less than 5% of maximum rated energy per cycle, a smaller shock absorber should be used.
C. If initial impact force is too hard, the next lower dash number (less damping) may be required. If bottoming
is too hard at the end of stroke, the next larger dash number (greater damping) or a larger model may be
required. For additional information, refer to the Bimba catalog under Shock Absorbers.
D. Do not clamp or weld shock absorber body. Do not paint or damage surface finish of the piston rod.
Mount and lock shock absorber in place; provide a positive stop from face of piston (or button), equal to the
stroke length as shown in the table below.
Bimba
25150 S. Governors Hwy
University Park, IL 60484
Tel: +1 800 44 BIMBA
Fax: +1 708 235 2014
Email: [email protected]
Website: www.bimba
/
